HS880
HIGH POWER HORN SPEAKER
80W 100V LINE
Technical Specifications
Power rating
Primary Impedance : 1
2
3
4
Freq response@ 1KHz +/- 3dB
SPL ( 1 W/m @ 1 KHz )
Flare material
Overall size
Weight
Colour
80W 100V line
125 Ohm
160 Ohm
250 Ohm
500 Ohm
160 ~ 6 KHz
110 dB
Aluminium
Aluminium Diecast
4 kg
Beige
Introduction
Constructed using rounded aluminum flare of 20” (HS880) with multiple power selection. It is
suitable for schools, mosques, fencing perimeters etc, which requires loud and clear broadcast.
(IP 65 rated ).
Its rounded aluminium flare provides more controlled audio dispersion and most suitable for areas
such as car parks, wide corridors, parks etc.
Guide to Installations
Power tapping (W) 20 / 40 / 60 / 80
Flare dimension 20” round
INSTRUCTION MANUAL
precision design, absolute confidence
Driver enclosure
335(H) x 504(D) mm
1 : Unpacking and check contents.
Unpack the horn speaker from the box, the following items shall be available:
1. Horn flare
2. Speaker cone
3. Speaker driver
4. Speaker bracket
5. Screws for installation cone and bracket
6. Instruction manual
2 : Install the cone to horn.
4 : Install the driver to horn.
Push in the Cone
bracket
Driver
Install the screws
Recommended size for wall screw ( not supplied ):
Diameter Length
1) Screw M4/M5 30mm
2) Wall Plug 9mm 30mm
Dismantle the speaker bracket from the unit in preparation to install the speaker bracket to the
wall.
Secondary Impedance (Ohm) 16
3: Install the bracket to the horn flare assembly.
bolt
Spring washer
washer
Mount Bracket
bolt
Spring washer
washer
Mount Bracket
NutNut
Install the mount bracket and nut from the inside of the horn
Mount BracketMount Bracket
horn
