AMX RDM-3SWM Assembly instructions

Installation Sheet
RDM-3SWM Triple Switch Module 20A
The RDM-3SWM Triple Switch Module is a 20 A triple general purpose
relay module built for compact and economical switching of incandescent
lamps, switched low-voltage transformers, switched fans and electrical
outlets. It is designed for use with the RDA series of enclosures, in an AMX
Lighting™ modular digital dimming system. The RDM-3SWM uses positive
air gap type relays. This module's 120, 240, and 277 VAC ratings are CE,
UL, and C-UL approved.
RDM-3SWM UL and C-UL Ratings (per circuit)
• General purpose: 2400 W
• Resistive: 2400 W
• Ballast: 2400 W
• Motor: 277 VAC, 1 hp
Suggested Switched Loads
• Incandescent
• Low-voltage
• Motors
• Switched outlets
• Fluorescent
Specifications
• Non-phase dependant
• Use wires rated at 75°C (167°F)
• Torque terminals to 7 in-lbs. (0.8 N/M)
• Max. wire size: 10 AWG (4 mm²)
• Wire stripping length: 0.28" (7 mm)
• Weight: 0.95 lbs. (0.43 kg)
• BTU/hr: 5 each (15 total)
• Control current: 85 mA per relay (255 mA total) @ 12 VDC
Caution: Pre-Installation Notes
• All Class 1 wiring must be connected to proper terminals.
• All control wiring must be connected to proper terminals.
• Disconnect power while installing or connecting the unit.
• Keep top and bottom air bents clear at all times.
• Test loads for shots before connecting.
• Use low voltage wires with a 300 volt rating or greater.
• Use field installed copper conductors.
• All electrical ratings are for continuous duty.
• For indoor use only.
• This module may require extra power from the AXlink connection or an
external power supply connected to the control card.
Connecting the RDM-3SWM to the AMX Lighting Master
FIG. 1 RDM-3SWM Triple Switch Module
Relay A
Relay B
Relay C
Line in (hot)
Load out
Mounting
points
Low-voltage control wiring:
4-pin connection to AMX
Lighting master controller
FIG. 2 RDM-3SWM connections
Pin 4 (GND)
Pin 3 (RLY)
Pin 2 (DIM)
Pin 1 (+12 V)
3 (-)
1 (+)
RDM-3SWM 4-pin module connector
4-pin plug from RDM series module
NOTE: The 4-pin plugs from the module connector to
the 4-pin connector on the master (black plug cover facing up).

AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
043-019-2204 2/02 ©2002 AMX Corporation. All rights reserved.
The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.
3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax [phone] • technical support 800.932.6993
Lighting Application Drawings
FIG. 3 RDM-3SWM Triple Switch Module 2400 (x3) line wiring configuration