AnaJet mPower Series Installation instructions

_____________________________________
. . . . . . . . . . ………………………………………………………… ..
Maintenance Station Replacement
Technical Support
Version 1.1
February 19, 2014

Technical Support
Troubleshooting –Maintenance Station Replacement
Page 2 of 7
Contact Info
Corporate Office:
AnaJet Inc.
3050 Redhill Ave
Costa Mesa, CA 92626
USA
Telephone:
714.668.6000
Toll Free:
877-6-ANAJET (877.626-2538)
Fax:
714.662.3600
Revision History
Revision
Description
Author
Date
1.0
1.1
Initial release.
i-Series update
Ray Larason –Technical Support
Robert Herman- Technical Support
January 3, 2012
February 19, 2014
Replacing the Maintenance Station
Introduction
This is a step by step guide on how to replace the maintenance station assembly.
Scope
This applies to mPower and mPower i-Series printers only.
Symptoms
Problems with the maintenance station not pulling ink or damaged parts on the
maintenance station assembly.

Technical Support
Troubleshooting –Maintenance Station Replacement
Page 3 of 7
Step 1
The first thing we want to do is release the print head carriage in the
maintenance functions menu. Then power the printer down with the switch on the
back. Remove the drip pan located underneath the maintenance station. To do
this remove the 2 screws holding it in then pull the tray out of the machine.
Please see picture below.
Step 2
Next, notice where the maintenance station assembly connects to the base it is
screwed in to. We want to mark this edge with a sharpie or marker so that we
can place the replacement maintenance station in the same exact spot as before.

Technical Support
Troubleshooting –Maintenance Station Replacement
Page 4 of 7
You want to make vertical lines over this seam, which means there will be a mark
on the base and the old maintenance station.
2.1
Once the old maintenance station is removed, measure the position of the marks
then use these measurements to draw the same marks in the same position on
the new maintenance station.

Technical Support
Troubleshooting –Maintenance Station Replacement
Page 5 of 7
Step 3
After marking this edge, remove the 4 screws holding the maintenance station
assembly to the base. Once the 4 screws are removed, you will be able to lift the
maintenance station off the base. See picture below.

Technical Support
Troubleshooting –Maintenance Station Replacement
Page 6 of 7
Step 4
Once you take the maintenance station off its base, you must remove the 5 wires
plugged into the board located underneath the maintenance station. You also
want to disconnect the drain tube from the waste ink tank. See images below.

Technical Support
Troubleshooting –Maintenance Station Replacement
Page 7 of 7
Step 5
Once the old maintenance station is removed, you can now install the new
maintenance station. Make sure to align the new maintenance station to the
marks you drew in step 2. Once the maintenance station is installed you will need
to adjust the Wiper Height. Please see TD&R “Wiper Blade Adjustment’” for
correct steps to adjust wiper height.