anko 42949244 User manual

BLUETOOTH PARTY SPEAKER
42949244

1
Warning
Contents
Warning 1
Important precautions 1
Package contents 2
Description of rear panel 3
Description of Remote Control  4
Getting Started  5
Function Instructions 6
and GuitarConnect Wired Microphone 8
Warranty 9
CAUTION
RISK OF ELECTRIC
SHOCK DO NOT OPEN
The lighting flash with
arrowhead symbol, with an
equilateral triangle is
intended to alert the user to
the presence of uninsulated
dangerous voltage within
the products enclosure that
may be sufficient magnitude
to constitute a risk ofelectric
shock topersons.
CAUTION: TO REDUCE THE
RISK OF SHOCK, DO NOT
REMOVE COVER (OR BACK).
NO USER SERICEALBE PARTS
INSIDE REFEER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
The exclamation point
within an equilateral
triangle is intended alert
the user tithe presence of
important operating and
maintenance (servicing)
instructions in the l
iterature accompanying
the appliance.
Important precautions:
1. The apparatus shall not be exposed to dripping or splashing and that no objects filled with
liquids, suchas vases, shall be placed on the apparatus.
2. Minimum distances 100 cm around the apparatus for sufficient ventilation.
3. The ventilation should not be impeded by covering the ventilation opening swith items,
such as news papers, table-cloths or curtains.
4. No naked flame sources such as lighted candles,should be placed on the apparatus.
5. When the mainsplug or and appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
6. To be completely disconnected the power input, the mains plug of apparatus shall be
disconnected from the mainscom pletely.
7. The main plug of apparatus should not be obstructed or should be easily accessed
during intended use.
8. The use of apparatus in moderate climates.
9. Attention should be drawn to the environmental aspects of battery disposal.
10. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
11. Excessive sound pressure from earphones and headphones can cause hearing loss.
12. The internal battery is non-user replaceable.
13. Do not use this apparatus near the water.

Package contents
2 3
Product specications
Speaker
1.Speaker x 1
2.Remote control x 1
3.AC power cable x 1
4.User manual x 1
5.AUX in Cable x 1
Power Supply : 220-240V~ 50Hz
FM Radio : 87.5-108MHz
Speaker : 12 Inch * 2 + Treble
Battery : 12V 7Ah
Line In : 3.5mm
Microphone Input : 6.35mm
DC Input(external) : 12V
DESCRIPTION OF REAR PANEL
1
2
3
4
5
6
8
7
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
1.Previous Button
2.REC Button
3.MODE Button
4.Power Button
5.Charge RED Battery Indicator
6.DC 12V 5A Input
7.AC Input
8.LED ON/OFF Button
9.Volume Knob
10.Next Button
11.Treble Knob
12.Bass Knob
13.Audio Output Jack
14.AUX Input Jack
15.Play/Pause Button
16.PRI (Priority) Button
17.USB Input Slot
18.TF Card Slot
19.MIC Volume Knob
20.MIC Echo Knob
21.MIC Dleay Knob
22.MIC Treble Knob
23.MIC Bass Knob
24.Guitar Knob
25.Microphone 6.35mm Input Jack
26.Guitar 6.35mm Input Jack

4 5
DESCRIPTION OF REMOTE CONTROL
1. Power on/off
2. Mode
3. Mute
4. Volume+
5. Previous Track/CH-
6. Scan
7. 0-9 keys
8. EQ Function
9. Play/Pause
10. Next Track/CH+
11. Volume -
12. Repeat
To insert the remote control batteries:
1.Open the battery compartment.
2.Insert 2 x AAA batteries with correct polarity (+/-) as indicated.
The 2xAAA battery not include in our products.
3.Close the battery compartment.
3
1
2
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Getting Started
Connecting Power Cable
Warning:Ensure the AC/Charge switch is in OFF position before plugin.Plugin the AC
connector into the 220-240V 50Hz inlet socket in the rear panel of the unit and the
other end into the standard AC 240V wall socket.
1. Do not plug or unplug the power cable while you have wet hands.
2. To protect this apparatus from alightning storm, or when left unattended and unused for
long periods of time, unplug power cable from the wall outlet.
3. When unplugging the power cord from a wall outlet, always pull on the power plug only.
Never unplug it by pulling the power cord.
Charging the internal Battery
The speaker comes with a built-in rechargeable battery, follow the below steps
to charge it:
AC INPUT(220-240V) Charging
1. Please connect the power cable on the rear panel and plugin to the 220-240V 50Hz wall
socket to charge the speaker.
2.When start charging, the RED LED indicator will light on.
3.When almost full charging, the RED LED indicator will keep flashing.
4.When full charge, the RED LED indicator light will light off.
DC 12V IN Charging
Connect the DC cable of the external power supply to the DC 12V IN terminals of the
speaker rear panel, please corresponding connect to the Red (+) and Black (-) indicated.
Noted: This DC input not for the battery charging, only supply the power to work for the
speaker.
Note:please fully charge the product when it is not going to be used for a long time and
charge once a month to keep longer battery life.
Turning ON/OFF the speaker
1.Press Power ON/OFF button on the rear panel to turn on or off the speaker.
2.Use the remote control to turn it into Standby mode, press it again to power it on.
Intrenal Battery Level indicator
1.There are three grids battery indicator symbol keeping static on the right bottom corner of
the display screen, meaning battery capacity is full.
2.As the battery capacity less, the battery indicator symbol will become as two grids.
3.When the rest one grid battery indicator and keeping flashing,meaning the battery
capacity is almost running out, please charge the battery on time, otherwise the speaker
will turn off.
Note: There is the low battery warning sound "DI DI" per 10 seconds when the battery
capacity run out as above 3.

6 7
Function Instructions
USB Operation
This unit has a USB port for play back MP3 music.
· Insert your USB device into the USB port and the unit will start playing automatically.
Press the [MODE] button to USB mode is selected.
· Press the or key to the previous or next track.
· Press the button to play or pause music
· Press button on the remote to repeat the current track, press it again to repeat all
tracks.
FM Operation
This speaker supports FM radio function.
1.This speaker has built-in antenna, no need to insert FM antenna.
2.Press [ MODE ] button on the rear panel or on the remote control repeatedly until FM
function is selected.
3.Short press button on the top panel to search the FM radio station automatically.
4.Press or to select the previous or next FM radio station.
Bluetooth function
1.Press [ MODE ] button on the top panel switch to the Bluetooth mode if the speaker on
other mode, there is a prompt sound.
2.Once on the Bluetooth mode," bLUE " will keep flashing on the display screen.
3.Open the Bluetooth funciton of the external device and search the Bluetooth device name
"42949244 " to pair.
4.Press connect to "PAIR" with the speaker.
5.Once connected, " bLUE " will keep static on the display screen and can hear a prompt
sound, you can play the music with the speaker.
6.You can use button or button on the rear panel or on the remote to control the songs
of the external device.
TWS Connecting
This speaker supports TWS pairing function, please buy two same speaker to enjoy this
function.
1.Turn on the Bluetooth function of the one speaker, connected the bluetooth and playing
music.
2.Long press MODE button on the rear function panel to open the TWS function, " "
will short display on the screen.
3.Turn on the bluetooth of another speaker and " bLUE " will keep flashing on the screen,
then long press [ MODE ] button of this speaker to open the TWS function, " " will
short display on the screen and "bLUE " will keep static.
4.Both speakers' TWS will pair automatically if above operation correct. Once TWS paired
successully, " bLUE " of both speaker will keep static.
5.Turn the volume knob on the function panel of any speaker increase or decrease the
music volume. 6.If not using the TWS function, please long press [ MODE ] to
deconnected TWS, " " will short show on the display screen, and " bLUE " will keep
flashing on another speaker.
Connect with AUX in
1.Press [ MODE ] button on the rear function panel to switch to the Line in mode," AUH " will
be displayed on the screen.
2.Connect this speaker Line in input jack and the device Earphone jack by provided Line in
cable (supplied in the accessories)
3.Once connected,turn on your external device and play music.
Caution: Please turn off the unit before connect AUX cable in order to avoiding unexpected
noise.
Function Instructions
Microphone REC Function
1.Before recording, please make sure the speaker insert a USB driver to save the record file.
2.When playing music, insert the microphone and long press REC button on the top panel to
turn on the recording function and the display will show “ “, then the speaker will
record the sound from the microhone to USB driver, you can speak any words or sing.
3.Short press REC button to stop the recoding and the recorded sound from the USB driver.
4.Short press REC button again can withdraw the playing record mode and back to USB
playing mode.
Note:Recording function only record the voice from microphone input.
Bluetooth and AUX input are not recorded.
PRI(Priority) Function
1.When playing music, long press PRI button on the top panel to turn on the weakening of
human vocal from the music , the display will show " "
2.Long press PRI button again to turn off the weakening of human vocal from the music , the
display will show " "
3.Short press PRI button on the top panel to turn on the microphone priority function, the
display will show " "
3.Short press PRI button on the top panel to turn off the microphone priority function, the
display will show " ”

8 9
Insert 6.35mm wired microphone, and use control knob to adjust
the sound level.
Connect to Wired Microphone and Guitar
Connect with Wired Microphone and Guitar
When playing with the wired microphone, please use these knobs to adjust the sound
volume/ echo volume/ delay volume/ treble volume/ bass volume of microphone.
Important Notes
While using the microphone, avoid being put the microphone opposite
the bass of Party Speaker,as they may have Whistler Noisy.
To get the best singing performance, keep the micro phone within
5-15cm of the mouth and at a 45 degree angle.
When using the microphone, always pay attention to the battery.
If the battery is low, the indicator light will come on and the
performance will progressively become poor.
Caution: Please do not put the microphone directly face to the
Party speaker, it may damage the speaker.
When insert the Guitar, please use the guitar volume to adjust the sound volume.
Warranty