anko M003 User manual

2-In-1 Reversible Stroller
Instruction Manual
0 - 36
months
MAXIMUM
WEIGHT
15
kg
THE ILLUSTRATIONS SHOWN IN THIS MANUAL ARE FOR REFERENCE ONLY. THE MANUFACTURER
RESERVES THE RIGHT TO CHANGE ANY SPECIFICATION OR FEATURE WITHOUT FURTHER NOTICE.
IMPORTANT! PLEASE READ CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE.

• Always fit and use the tether strap when the stroller is in use.
• When using the stroller, always ensure your hand is positioned in
and around the tether strap. The strap is a compulsory safety
feature which must be used at all times. It is for the safety and
benefit of your child.
• The correct use and maintenance of this stroller is essential.
• Ensure that all clamps and buckles are securely fixed and in
place before use.
• When in the stroller, your child must always wear the safety
harness, correctly fitted and adjusted, at all times.
FOLLOW THE MANUFACTURER’S INSTRUCTIONS.
Read these instructions carefully before use and keep for future
reference. The child may be hurt if you do not follow these
instructions.
ALWAYS APPLY THE BRAKES WHENEVER THE
PRAM/STROLLER IS STATIONARY.
DO NOT LEAVE THE CHILD UNATTENDED.
SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
DO NOT CARRY EXTRA CHILDREN OR BAGS ON
THIS PRAM/STROLLER.
ENSURE CHILDREN ARE CLEAR OF ANY MOVING
PARTS IF YOU ADJUST THE PRAM/STROLLER.
OTHERWISE THEY MAY BE INJURED.
USE THE HARNESS AT ALL TIMES.
USE THE TETHER STRAP TO STOP THE PRAM/STROLLER
ROLLING AWAY.
CAUTION: TO AVOID INJURY OR DEATH
NEVER LEAVE PRAM/STROLLER NEAR AN OPEN
FIRE OR EXPOSED FLAME.
IT IS UNSAFE TO USE ACCESSORIES OTHER THAN THOSE
APPROVED BY THE MANUFACTURER.

• The stroller will become unstable if the manufacturer’s
recommended load is exceeded.
• Use the stroller on flat or gently sloping surfaces. It may be
unstable on higher sloping and uneven surfaces - be aware of
the possibility of the stroller tipping over.
• Care should be taken if the stroller is used on stairs or
escalators.
• Care must be taken when folding and unfolding the product to
prevent finger entrapment.
• The stroller is not suitable for running or skating.
• Any goods carried in the basket are not to exceed 2 kg.
• Do not leave your child exposed to the sun. The canopy or
hood on this product will not give your child total protection
from the harmful rays of the sun.
• Take care when unpacking and during assembly.
• Dispose of all packing materials carefully after assembly.
• Never substitute parts.
•
•
It is unsafe to use accessories other than those approved by the
vehicle manufacturer.
The pram/stroller not be used near an open fire or exposed flame.
• The brakes must always be applied when the pram/stroller is
not moving.
• Never leave the harness buckles when not fitted to a child in
the stroller because the harness can form loops which may pose
a strangulation hazard.
• The maximum weight of the child for which this stroller is
intended is 15kg.

FRAME SEAT AND BUMPER BAR
CANOPY FRONT WHEELS
REAR WHEELS
PARTS

UPWARDS
Rear wheel parts
① ② ③
④ ⑤
①
②
SET UP THE FRAME
FRONT WHEEL INSTRUCTIONS
REAR WHEEL INSTRUCTIONS
Remove the stroller frame
from the box. Pull the handle
bar in an upwards and forwards
motion. It is fully extended
when a click is heard.
Note: It is necessary to check
all parts before assembly to
ensure there are no defects,
loose screws, sharp edges, etc.
Do not use if any parts are
broken or damaged.
Refer to illustrations:①②
Push each front wheel pin
into the front wheel socket
until a click is heard.
As shown in the illustrations:
Place one metal washer onto the
end of the rear axle ②,
place one wheel followed by
another washer ③, insert the
straight side of the cotter pin
through the hole in the axle to
secure ④, fit the cover ⑤；
Repeat these steps for the other
wheel.
Assembly Instructions
FORWARDS

RELEASE
RELEASE
To attach the seat unit to the
frame, line up the seat connectors
at either side of the seat unit with
the frame housing and press
down until you hear it click
into place.
To remove the seat unit press
the release buttons as
shown in the image and lift seat.
Insert the bumper bar into the
slots on either side of the seat
unit until a click is heard.
Give the bumper bar a tug to
ensure it is securely in place.
To remove the bumper bar, press
the release buttons on both sides
and lift o.
ATTACHING THE SEAT
BUMPER BAR INSTRUCTIONS
Insert the canopy into the
anchors on the seat in the direction
indicated by the arrow until it clicks
into place.
Fasten the grip fasteners to the
seat unit.
Open the zip to reveal the extension
panel for added sun protection.
CANOPY INSTRUCTIONS

RELEASE
Lift it up then release
FIX RELEASE
The front wheels are equipped
with a swivel locking device.
Push the button on each wheel
down to fix the locks and push
upward to disengage the locks.
The seat unit is reversible and
can be used forward facing or
rear facing.
Press the release buttons on each
side of the seat unit to remove
and rotate the direction. Line up
the seat connectors with the
frame housing and press down
until a click is heard.
Note: when using in bassinet
mode for newborns, the seat unit
should only be used rear facing.
This stroller has 3 recline positions.
The seat can be adjusted into upright,
half-reclined and reclined positions.
Pull the button on the frame, lift it up
and release button. The dierent
recline positions are in position
once a "CLICK" is heard.
Note: To adjust seat unit position
lift the release button and hold
while changing positions then release.
BACKREST ADJUSTMENT
FRONT WHEEL LOCK
SEAT DIRECTION ADJUSTMENT
REAR
FACING
FORWARD
FACING

ENGAGE RELEASE
1 & 2: Shoulder belt length adjustment
3 & 4: Waist belt length adjustment
5: Crotch belt length adjustment.
To engage brakes, apply
downward pressure to the brake
lever located on the rear axle.
You may need to roll the stroller
back and forth to engage the
brakes.
Check that the stroller will not
move once the brakes are
properly applied.
To release, gently lift up on the
brake lever.
Round release button
Safety belt
length adjustment
BRAKE OPERATION
Insert the shoulder strap buckle
①into the buckle housing of
centre hub.
Repeat on the other side ②.
Insert the completed waist
buckle ③+④into the buckle
housing.
Ensure all the buckles are in
place and securely engaged.
To release buckles, press centre
button on buckle housing.
The shoulder straps of the 5-point harness have 2 attachment positions. Select the position
that places the shoulder strap level with, or below the top of the child’s shoulder.
To adjust harness height unhook the shoulder strap from the crotch buckle. Feed the shoulder
strap through the harness slots. You can access these slots from the rear of the seat
underneath the fabric. Feed shoulder straps through the appropriate slots and reattach the
shoulder straps to the crotch buckle.
5-POINT SAFETY HARNESS

Remove the seat from the frame.
Fold the stroller by pulling both release triggers and press handle towards the floor.
Note: Fold the stroller from upright position. Fold down so the handle is level with
the rear wheels, secure with the locking latch on the side of the frame before lifting.
TO FOLD THE STROLLER

This stroller was designed and manufactured
with quality materials and craftsmanship.
Always use the safety harness.
Always check your stroller.
Lubricate moving parts regularly, especially
the wheels, and the lower parts of chassis
that tend to collect dirt.
Worn parts, torn materials or stitching.
Loose screws, bent or broken frame parts.
Broken, damaged or missing parts.
Should any of the above be evident, do not use.
Any additional replacement parts should only
be obtained from the manufacturer or distributor.
Seat/ Basket/ Canopy:
Wipe clean with a damp cloth.
It is not recommended to expose to salt water.
Rinse with fresh water immediately.
Do not fold or store the product while wet and
never store in a damp environment as this can
cause mildew to form.
Allow to dry thoroughly after washing and
before storage.
Made in China
Keycode 42967767
FOR AU / NZ: IMPORTED FOR KMART STORES IN AUSTRALIA AND NEW ZEALAND.
Care and Maintenance
General
Inspect regularly for:
Care and Maintenance: