Special Tomato Jogger User manual

TM
ITEM# 62000000
REVISION: 01/14
UMJOG01-14LIT
Optional Liners
shown
user’smanual

In the interest of your priceless cargo, please read these warnings before
using your Tomato Jogger.
WARNING:AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT. ALWAYS USE THE
SEAT HARNESS.
NEVER LEAVE CHILD UNATTENDED.
IMPORTANT: KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. A CHILD'S SAFETY IS YOUR
RESPONSIBILITY. THIS JOGGER IS SUITABLE FOR ONE CHILD. ALWAYS USE THE ATTENDANT
STRAP. TOTAL WEIGHT LOAD RECOMMENDED FOR THIS JOGGER IS 110LBS OR 50 KG.
GENERAL INFORMATION & SAFETY
•Front wheel must be kept in-line for exercise.
•Follow all instructions carefully. Incorrect use will cause damage to push
chair.
•This product has been designed to take the maximum weight of 110lbs
(50kg).
•Children should be harnessed in at all times and should never be left
unattended.
•IMPORTANT - It is important for your child’s safety that the
harness be correctly tted and adjusted. If not adjusted correctly in
accordance with the instructions, the stability of the Jogger will be
compromised.
•The harness and seat belt are not a substitute for proper adult supervi-
sion.
•The child should be clear of moving parts while making adjustments.
IMPORTANT - DANGER: It is important that care is taken to
ensure that children are kept clear of the Jogger when folding or
unfolding. Pinch points and scissoring actions are unavoidable during
these operations.
• Do not carry additional children, goods or accessories in or on this push
chair except as permitted in this manual. They may cause the Jogger to
become unstable or place unneeded stress on the Jogger that could lead to
breakage.
• Overloading, incorrect folding and the use of accessories, e.g. child seats,
bag hooks, rain covers, buggy boards, etc., other than those approved by the
manufacturer may damage or break this Jogger.
• Any damage caused by the use of accessories not supplied by manufacturer
will not be covered by the terms of our warranty.
• Never leave child in the Jogger when ascending or descending stairs or
escalators or when travelling on other forms of transport.
• The Jogger should always open and fold easily. Do not force it. It may be
necessary to re-read the instructions.
• Negotiate curbs and rough ground carefully. Repeated impact will cause
damage to the push chair.
• Never allow children to stand on the footrest.
• Do not leave the Jogger exposed to heat, i.e., by a radiator or in direct
sunlight.
• Do not place items on the top of the hood as it may cause damage to the
canopy.
MAINTENANCE AND REPAIR
This Jogger requires regular maintenance by the user. Before each use
check all rivets and connecting devices for tightness and security. Inspect all
brakes, wheels, and tires and replace or repair if necessary. Check all safety
devices for correct operation.These should be free to move at all times.
Never continue to use a product that is not structurally sound.
• We recommend a service every 12 months.
• If wheels squeak, lubricate sparingly with Teon or silicone coating. Do
NOT use oil or grease based products, as this will attract dirt, which will
clog the movement.
• Only manufacturer replacement parts should be used. It may be unsafe to
use parts not supplied by manufacturer.
CLEANING
• Clean frame with a damp cloth and a mild detergent and dry.
• If the Jogger parts have been exposed to salt water, we recommend
that they be rinsed down with fresh (tap) water as soon as possible.
• The canopy may be sponged lightly using a damp cloth and a mild
detergent.The seat cover and head cushion may be washed. Line dry
before reuse.
• Do not fold or store the product while wet and never store in a damp
environment, this can cause mildew to form.
The manufacturer reserves the right to make design changes to any of its
products as part of its continuous design improvement program.
INSTRUCTIONS
IMPORTANT:
• READ THESE INSTRUCTIONS CAREFULLY BEFORE USE
AND KEEP THEM FOR FUTURE REFERENCE.
•YOUR CHILDREN’S SAFETY MAY BE AFFECTED IF YOU
DO NOT FOLLOW THESE INSTRUCTIONS.
• APPLY BRAKE WHEN PARKING THE JOGGER.

Contents
Frame
Front Wheel Attachment
Front Wheel In-line Locking
Rear Wheel Attachment
Safety Harness
Parking Brake
Recline Seat
Removing Seat Fabric
Shopping Basket
Canopy Attachment
Handle Height Adjustment
Folding & Optional Liners
2
3
3
4
4,5
6
6
7
7,8
8
8
9

Frame
Unpack Jogger from box and set wheels aside.
1. Push foot plate of Jogger away from handle by
pushing curved crossbar up and out.
2. Audible click will be heard when Jogger frame
is completely unfolded.
3. Flip Jogger to upright position.
4. Clip lower belting around frame to secure seat
fabric.
2
1
2
3
4

Front Wheel
To install front wheel, lay jogger on it’s back so
handle and rear axles are touching the oor.
5. Engage safety lock on both sides of the fork as shown in
image 5. Check before each use.
6a. Insert the Front Wheel into the fork tips by aligning the
axle ats with the fork tip at surfaces.
6b. Tighten by turning the wheel lever and securing the
other side.
6c. Close the wheel lever making sure that it is ush with the
tubing. Be sure not to over tighten.
Front Wheel In-line Locking
Front wheel must be kept in-line for exercise
7. The in-line locking mechanism is located be-
hind the front wheel pivot point. Pull and rotate
knob to lock and unlock. Image shows unlocked.
8. Image now shows the wheel locked in-line. Pull
and rotate mechanism to unlock.
3
6
6a
6b
6c
*Safety Lock - both sides
5
6
7
8

Rear Wheels
9. To install, gently slide the rear wheel’s axle into
the frame’s supporting axle hole until you hear it
click into place.
10. To remove, simply push down the spring lock
tab while pulling out on the wheel.
Safety Harness
Adjusting safety harness:
11a. Unclip hooks.
11b. Remove eece lining (Velcro tabs shown
above).
CLICK!
4
9
10
11
11b

12. Unthread harness straps from eece lining.
13a. Adjust shoulder straps to desired height using
the loops on the seat back.
13b. Slide the plastic guide up and down to adjust
strap length.
Once tting is complete, reassemble the eece
lining.
14a. Clip both shoulder straps to the eye holes
located on the buckle mechanism.
14b. To adjust the length of the center strap, move
the plastic guide up and down.
5
12
13
14

Rear Wheel Parking Brake
To apply the parking brake:
15. Press down on the foot bar.
Disengage the brake:
16. Pull up on the foot bar.
Reclining Seat
17. Simply adjust the recline strap length to de-
sired degree of recline.
18. Unlock the buckle shown in Figure 17 for
maximum recline.
6
15
16
17
18

Removing Seat Fabric
19. Using a phillips head screw driver unscrew
hardware from the frame.
20. Unsnap fasteners on both sides of jogger.
20a. Unlock seat strap from frame, buckle is sus-
pended across the back of the jogger.
21. Unloop Velcro Strap through the D-ring, un-
derneath the foot well.
NOTE: REMOVE ALL RIGID PARTS BEFORE WASHING
Joggers are shipped with Seat pre-assembled.
Assembly/ Removal instructions are given if any
pre-assembly items are removed for cleaning or
replacement. “SEE PAGE 10”
Shopping Basket
22. Secure front basket ap by snapping around
the lower foot well crossbar.
7
19
20
21
22
(Detail of front
shopping pocket snaps)

23. Wrap rear basket straps around the frame and
loop back through the D-ring. Secure the Velcro
strap.
Note: The D-ring loops are at the rear of the basket.
Canopy
24. Fasten the canopy to the portion of the upper
frame that is not covered by fabric. Small holes
in the crest of the frame tubing accept the can-
opy. Be sure there are NO obstructions between
the canopy clip and the frame. There is a small
plastic nipple on the canopy mechanism that ts
into the hole in the frame.
25. Hook the wire on the back side of the can-
opy mechanism and then close the lever by
pressing it to the frame (Figure 25). DO NOT
FORCE TO CLOSE! Double check for obstructions
and be sure nipple is inserted into frame.
Handle Height
26. Unlock lever on both sides of handle. Adjust
to height. Then relock.
8
23
24
25
26

Folding
To ease Jogger Folding:
• Fully recline seat back
• Disengage Velcro Between Canopy & Seat Back
• Push handle all the way up
• Unlock front wheel swivel lock
• Undo 5 point harness
27. Squeeze mechanism located below the
handle. (Mechanism located on Both Sides)
Fold jogger back.
Optional Special Tomato Liners
28. Back Liner:
Using the provided straps that come with the
back liner – Feed straps through the slots in the
jogger seat back. Extra slots provide adjust-
ment.
(Do not feed Jogger shoulder straps through
liner.)
29. Seat Liner:
Use attachment straps provided with the seat
liner to fasten the optional back pad to the jog-
ger.
Then feed the original jogger seat buckles up
through the seat liner. [White Buckles]
9
Recline strap secures Jogger
in folded position.

Attendant Strap
• Make sure safety wrist strap is secured properly
around your wrist whenever your child is in the
jogger.
Washing
• You can machine wash your Jogger seat in
cold water with a mild detergent. To minimize
shrinkage, simply reattach the seat to the frame
to dry. ( DO NOT put seat in the dryer)
• Be sure to remove the rigid back board from
the seat before washing. Unzip seat back and
remove rigid back support.
• You may clean the Jogger frame using a soft,
dry cloth.
© 2014 Bergeron By Design
The information contained herein is subject to change without notice.
Bergeron By Design shall not be liable for technical errors or omissions herein.
T 1 315 429 8407
F 1 315 429 8862
AUTHORISED EUROPEAN
REPRESENT
AT IVE
GLOB
AL CAREHAB
R
OSENVANGS ALLE 32
8260
VIBY J
DENMARK
[phone]
LIMITED WARRANTY
Your push chair is guaranteed to be free from any manufacturing defects for a period of 2
years from the date of purchase under normal use and provided it is used in compliance
with the operating instructions.This warranty extends only to the original retail purchaser
and is only valid when supplied with proof of purchase. Please retain proof of purchase
with this Limited Warranty.
Should a repair be needed please contact the retailer from whom the product was
purchased.
Please note that the warranty will not be applicable if:
A fault is caused by misuse or poor maintenance.
Repairs are carried out by a third party.
The Jogger is faulty due to general wear and tear which is the result of everyday
use.
The Jogger is damaged as a result of an accident.
The manufacturer is not satised that the stated warranty terms and conditions have
been met.