anko 42965824 User manual
User Manual
CAMP CARAVAN THERMOMETER
Keycode: 42965824
1. Introduction
The following user guide provides step by step instructions for installation and operation.
2. Getting Started
2.1 Parts List
QTY
Item
1
Display Console
Frame Dimensions (LxWxH): 7.5 x5.8 x 1.9cm
LCD Dimensions (LxW): 4.1 x5.2cm
1
Manual
2.2 Display Console Set Up
Note: To avoid permanent damage, please take note of the battery polarity before
inserting the batteries.
BEFORE inserting the batteries, change Celsius/Fahrenheit Switch FIRST (the default is
Celsius) Figure 1- if necessary. If you want to change the temperature unit when the unit is
working you need to take out the batteries first. Then switch C/F as Figure 1 and re-insert
batteries. Important: You need to change temperature unit (C/F) before the item is
powered on.
properly.
Verify the correct temperature unit of measure (°F vs. °C) are on the display as shown in
Figure 3
Figure 3
Replace the battery door, then fold out the desk stand and place the console in the upright
position, as shown in
1.Out temperature unit (°F or °C)
2.Outdoor lowest temperature
3.Indoor temperature unit (°F or °C)
4.Indoor lowest temperature
5.Indoor highest temperature
6. 24hours automatically cleared
7.Indoor temperature
8.Outdoor highest temperature
9.Outdoor temperature
Figure 4.
Figure 4
2.3 Sensor Operation Verification
Verify the indoor and outdoor (probe) temperature match closely. The sensors should be
within 2°C (the accuracy is ± 1°C). Allow a few minutes to stabilize.
3. Specifications
3.1 Measurement Specifications
The following table provides specifications for the measured parameters.
Measurement
Range
Accuracy
Resolution
Indoor Temperature
0~60ºC
± 1 °C
0.1 °C
Outdoor Temperature
-40 to 60 °C
± 1 °C
0.1 °C
3.2 Power Consumption
•2 x AAA1.5VAlkaline batteries
•Battery life: Minimum 24 months for base station
Made in china
Table of contents
