Anyload 110BHM3 User manual

110BHM3
Weigh Module
Installation Guide
AL-Instruction-Weigh Module-110BHM3-12/13Page 1 of 7

Contents
1. Introduction ……………………………………………………….….………3
2. Replacement Parts & Installation Tools …………….……………4
3. Installation Steps ……………………………………………………………4
4. Integral Installation ………………………………………..………………6
5. Dimensions …………………………………………………….………………7
AL-Instruction-Weigh Module-110BHM3-12/13Page 2 of 7

●To use with tension link load cell 110BH
● Capacities: 500kg...10t.
●Tension loading design, no threaded connection in between.
●Self checking, patented hole design provides high repeatability.
●Multi-directional movement.
●Can withstand bigger bending and torsional force while providing a higher
safety factor
1/ Introduction
AL-Instruction-Weigh Module-110BHM3-12/13Page 3 of 7

INSTALLATION TOOL
1. Outer Hexagonal Wrench
2. Plier
Step 1:
Put the load cell in one of the clevises, and insert the pin. Keep the load cell in
the middle of clevis, do not brush with the clevis. As shown in the figure below.
2/ Replacement Parts & Installation Tools
3/ Installation Steps
AL-Instruction-Weigh Module-110BHM3-12/13Page 4 of 7

Step 2:
Insert the cotter pin in the hole at the end of straight pin, and open the cotter
pin with the plier. Keep the load cell in the middle of clevis, do not brush with
the clevis . As shown in the figure below.
Notice:
The angle of Cotter pin is 60 °in principle.
The cotter pin must be okey at a time, cannot be used again and again.
Step 3:
Repeat step 1 and step 2. Install the second clevis to the other end of the load
cell, on straight pins and cotter pin. As shown in the figure below.
AL-Instruction-Weigh Module-110BHM3-12/13Page 5 of 7

Step 4:
Tighten the screws to install the bonding strap. As shown in the figure below.
4/ Integral Installation
5/ Dimensions
Jam nut must be tightened
Jam nut must be tightened
AL-Instruction-Weigh Module-110BHM3-12/13Page 6 of 7

AL-Instruction-Weigh Module-110BHM3-12/13Page 7 of 7