AOpen Digital Engine DE945-FL User manual

Assembly Guide for DE-945FL
V1.1
2007/07/10

Index
1. OPEN HOUSING ………………………………………………2
2. INSTALL KEY COMPONENTS ………………………………4
3. ASSEMBLE THE SUPPORTER & UPPER CASE …………8
4. CPU SUPPORT LIST ………………………………………….12
APPENDIX ……………………...…………………………………13
1

1. Open Housing
1-1 .
Unscrew the upper case (2@FPH M3 screws in
rear side)
1-3. Remove the Upper case
1-2. Unscrew the upper case (2@FH M3 screws
in top side ).
Front side
Rear side
2

1-4 Unscrew 4 screws from Heat sink 1-6. Remove the protection from Heat sink
thermal tape
1-5. Unscrew 3 screws from supporter 1-7. Remove the protection from supporter’s
thermal tape
3

2. Install Key components
2-1 Install CPU
2-1-1. Rotate the screw in counterclockwise
direction
2-1-2. Put the CPU in the socket and make sure
that the triangle mark on the CPU is in the same
direction with the same mark on the socket.
Rotate the screw in clockwise direction
4

2-2 Insert memory module
Insert the memory module in upper slot in 30
degree angle as shown in the picture, push
down the memory module slowly till there's a
clipping sound.
5

2-3 . Assemble the hard disc
2-3-1. Insert the SATA hard disc into the
support with about 30 degree angle
2-3-2 Screw the hard disc on the supporter
with 4@FPH M3 screws
6

2-4. Assemble the internal card
2-4-1. Assemble the the internal card and the
hard disc
2-4-2. Screw the internal card on the
supporter with 2@M2 screws
7

3. Assemble the Supporter & Upper Case
3-1. Assemble the supporter and lower case
3-1-1 Insert the internal card into the slot on
motherboard
3-1-2 Screw the supporter on the lower
case with 2@FH M3 screws and
1@FPH M3 screw
8

3-1-3 FPHM3Screw
FH M3 Screw
3-2. Assemble the heatsinkk
Screw the heatsink on the lower case
9