AP&T AP-AC2456 User manual

Shanghai Anping Static Technology Co.,Ltd
3/F, Building 27, No.69, Guiqing Road, Shanghai, China
Tel：[phone]
Fax：[phone]
www.ap-static.cn
IONIZING AIR GUN
AP-AC2456
User Manual
Shanghai Anping Static Technology Co.,Ltd

7. Warranty and After Sales Service
(1) AP-AC2456 ionizing air guns are strictly inspected before
ex-work and match all the related technical standard
indicated in this manual.
(2) AP&T PROMISE ：Repair or change any damaged parts
caused by quality reasons free of charge within one year
from the date of purchase after we confirm the quality issue.
(3) Above promise is not fit for the following situation ：
Alternation of the device, wrongly used, incorrect installation,
abasement, negligence, accidental damage, wrong input
voltage, unpacking and repacking by user itself or maintain
by other unauthorized service department.
(4) AP&T is free from any related responsibility of using the
product except the parts specified here above.
8. Caution
User must install air filter before input air to guarantee the
input air clean and dry and avoid the wet air get into the gun
head thus cause short circuit in high voltage power
generator.
Ionizing air gun
1. General
AP-AC2456 ionizing air gun is a small, light, fast and
effective device to provide static protection for objective
surface.
AP-AC2456 ionizing air gun applies the modern positive
and negative ion interchange technology. It generates a
symmetrical ion group on one electrode and transmits the
ion to the objective surface with static by compressed air. It
can eliminate the static on objective surface efficiently and
keep the remaining static at low level.
2. Features
(1)Small dimension, easy to install, flexible operating and
reliable.
(2) Clean the dust at the mean time of static removing.
(3) Must be used by equipped with AP-AC2455 generator
4. Installation & Operation
(1) Connect the power cord
of the air gun to the
high voltage output
end ofAP-2455 generator.
(2) Switch on the power
generator, LED indicator on.
(3) Connect the working air
AP&T
AP-AC2456

source. Adjust the pressure controller to proper value to
reach the optimum effect.
Air gun should be close to the working area (appro. 150-300mm
to the target objective) when using. Air exit must aim to the
target objective. By adjusting the input air pressure and gun
angle could reach the optimum static removing effect.
5. Maintenance
(1) Take off the air cap in front of the air gun and observe the
head of the alloy electrode. Change the electrode when it
becomes obtuse while not sharp to guarantee the
effectiveness of the static removing.
(2) If the indication light keep off user should stop operating the
device and ask for maintenance. Device can only be used
when the generator is under normal condition.
(3) Lubricant should be appended regularly to keep air source
switch smooth.
6. Safety
(1)Be aware to read this user manual carefully before install
and use this device.
(2)Do not locate this device in the environment with high
moisture.
(3)Do not use this device in the flammable and explosive
surrounding.
(4) Earth wire of the air gun and power generator should be
connected reliably to guarantee the user safety.