APART VINCI 4 User manual

VINCI 4
Instruction manual
Installed Sound Solutions
2 3 4
Instruction manual Instruction manualVINCI 4 VINCI 4Limited edition high-end loudspeaker
VINCI 4 Introduction
Thank you for purchasing the Apart VINCI 4.
VINCI 4 sets new standards in affordable
reference bookshelf speakers. By keeping the
design as simple as possible, we managed to
create a true high end speaker with the highest
value for money. Of course, this is a typical
feature for all products of the Apart brand.
Compact, audiophile, neutral but captivating…
Each component was carefully ear-chosen and
tested. The result is an ultra linear performer,
with great dynamics and stable stereo imaging.
With the optional speaker stand, the speakers
are positioned at ideal listening height. When
properly installed, these speakers will provide
you with many years of listening pleasure. Just sit
back, relax and enjoy.
Please read this manual carefully before using the
product. This will give you the necessary product
and installation instructions to assure a seamless
installation and non-compromised overall sound
quality.
Safety instructions
• Keep this manual for future reference.
• Take care of your speaker wires, they should
be free of damage. Damaged speaker wires
may result in poor sound quality and can
damage amplifiers.
• No main power shall be connected to the
loudspeakers, doing so will damage the
speaker.
• This speaker should only be serviced by
qualified personnel. If not, warranty might
be void.
• Use cables of the right gauge, certainly for
long runs.

75 6
Instruction manualVINCI 4 Limited edition high-end loudspeakerLimited edition high-end loudspeaker
Connecting the speakers
Ideally, you should position the speakers
at ear level, but you can also mount the
speakers on the wall or against the ceiling
using our VINCI 5 bracket, available in
black and white. For more info about this
bracket, please check our website. VINCI
4 is also compatible with many other
commercially available speaker brackets.
Speaker positioning
Mounting holes with
suitable inserts are already
present at the back of the
speaker. The mounting
holes are spaced 58 mm
apart, located horizontally
in the middle of the
speaker. Screw thread
is M6, maximum thread
length is 12 mm.
Connect the positive or plus output (red) from
your amplifier to the red connector at the back
of the speaker. Connect the negative or minus
output (black) to the black connector at the back
of the speaker. No need to mention: always use
good quality speaker cable. The speaker terminals
accept speaker wire up to 2.5 mm² and 4 mm
banana connectors.
• Use cables with clear color indication and
maintain polarity throughout the whole
system.
• Avoid loud feedback from microphones,
this can damage your speaker.
• Please check the unit’s condition after
unpacking. If the outside of the carton
box has been damaged, inform your
shipper immediately.
• For indoor use only. Do not expose the
unit to outdoor weather conditions.
Recommended amplifier 10 to 120 watts, no
clipping
Nominal impedance 6 Ohm
Frequency response (+- 3
dB)
70 – 25000 Hz
Low frequency point 58 Hz
LF speaker 4 inch coated paper cone
HF speaker 3/4 inch silk dome
Cabinet Bass reflex
Dimensions HxWxD (mm) 210 x 136 x 164 (including
grille), 210 x 136 x 150
(without grille)
Weight 2.1 kg
Cabinet material High gloss finish MDF
Colour Black or white
Specifications
developed
by
Audioprof nv
Industriepark Brechtsebaan 8 bus 1
2900 Schoten - Belgium
Company names, product names and
trademarks are property of their respective
owners.
Apart-Audio specifications are subject to
change without notice.