AperionAudio Intimus 5B User manual

18151 SW Bo one s Ferry Road , Portla nd OR 97224
- 8 88 . 880 .8992
Intimus 5B
5.25" 2-Way Bookshelf Speaker
Owner’s Guide

Features
• 1" Audiophile-grade silk-dome tweeter
• 5.25" Woven fiberglass composite woofer
• HD-X3™ Impedance leveling crossover
technology
• Magnetic shielding
• Furniture-grade finish
• 5-Way gold-plated binding posts
• Anti-Resonant Cabinet
• Acoustically transparent grille
Specifications
Frequency Response: (+/- 3dB) 75-20,000 Hz
(+/- 6dB) 62-22,000 Hz
Nominal Impedance: 6 Ohms
Sensitivity: 84 dB
Recommended Power: 50 -150 Watts
Driver Configuration: 2-Way
Enclosure: Ported, 1" HDF
Dimensions: 12" H x 6.75" W x 8" D
Weight: 14 lbs.
Connections
To connect your speaker to your receiver you will
need standard 2 conductor, stranded speaker
wire. For instructions on installation, please read
below.
Preparing the Wire
1) Separate the last 4" of your speaker wire into
two pieces.
2) Strip 1/2" off the shielding off of the end of
each wire (see A below).
3) Twist the exposed copper strands with your
fingers until they are tightly unified. Be sure
there are no “flyaway” strands (see B below).
If You’re Using Bare Wire
1) Unscrew the binding posts on the back of
your speaker by turning counter-clockwise.
2) Insert the bare speaker wire into the hole in
the binding post and tighten it securely by
turning clockwise.
If You’re Using Banana Plugs
1) Be sure to follow the instructions on your
banana plugs to attach them to the wire.
2) Screw the binding posts in completely by
turning clockwise.
3) Insert them into the open end of the binding
post.
Note: As you make your connections, be sure to
connect the positive terminals on your receiver
to the positive terminals on your speakers.
Most two conductor wire has screen printing on
one side to help you differentiate between the
two strands (see image below).
AB
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
+
-
+
-
Features, Specifications, and Connections

2) In the crossover menu, select a crossover
point of 80Hz. If you’d like, you may set the
crossover point anywhere from 80Hz - 100Hz to
satisfy your listening tastes. (If your speakers are
set to “Large” your receiver should automatically
bypass the crossover.)
3) In the speaker distance menu, measure and
input the distance between your primary listen-
ing position and your speakers (see 2 below).
4) In the channel level menu you can set the vol-
ume level for each of the speakers in your system
(see 3 below). The goal is to adjust each speaker
to be the same loudness at your listening posi-
tion. You can set this by ear, but we recommend
using an SPL meter for best results. An SPL
meter can be purchased on our website. www.
aperionaudio.com.
Placement Recommendations
Each room is unique and unless the room was
specifically designed to be a home theater, its
acoustic properties will not be perfect. How-
ever, the following guidelines will help you get
the most out of your speakers. Try to match the
placement diagrams below as closely as you
can. If you’re using them as a surround speak-
ers, they should be placed about two feet above
the listeners’ ears. Also, don’t be afraid to ex-
periment with placement. Often a small differ-
ence in placement can yield a big improvement
in sound.
Setup
Setting up speakers through your multi-channel
receiver only requires a few simple steps. You
may have a receiver that has an auto calibra-
tion microphone, and while these are conve-
nient, they are not always accurate. For best
results, we recommend accessing the setup
menu of your receiver and manually setting up
the speakers. Most modern receivers use an On
Screen Display setup menu (OSD) that makes
setup a breeze.
1) In your receiver’s setup menu, go to “Speak-
er Setup” or “Speaker Configuration”. The
setting for this speaker should be “Small” (See
1 below).
Speaker Distance
Quit: SETUP
a. Units
b. Front L/R
c. Center
d. Surr Right
e. Surr Back R
f. Surr Back L
g. Surr Left
h. Subwoofer
feet
:12.0
:12.0
:11.0
:10.5
:8
:10
:13
2
Level Calibration
Quit: SETUP
a. Left
b. Center
c. Right
d. Surr Right
e. Surr Back R
f. Surr Back L
g. Surr Left
h. Subwoofer
: +1dB
: +6dB
: 0dB
: +3dB
: +7dB
: +5dB
: +5dB
: +6dB
3
a. Subwoofer
b. Front
c. Center
d. Surr L/R
e. Surr Back
:Yes
:Small
:Small
:Small
Quit: SETUP
1
:Small
Ideal Stereo Placement
45 to 60
Ideal Home Theater Placement
45 to 60
Left Front Right Front
Center
Left
Surround
Right
Surround
Back Right
Surround
Back Left
Surround
Left Front Right Front
Placement and Setup

An electronic copy of this manual can be downloaded from www.aperionaudio.com.
© 2007 Aperion Audio. All Rights Reserved. Version 1.1B.
Express Limited Warranty
Aperion Audio provides a transferable ten (10) year limited
warranty on our speakers; a transferable three (3) year
limited warranty on our subwoofer amplifiers; and a non-
transferable lifetime limited warranty on our cables. No
other warranty, implied or otherwise, is created or hon-
ored by Aperion Audio. These warranties cover all defects
in material and workmanship with the following specific
exceptions:
•Damage caused by improper installation or adjustment
•Damage caused by accident, unreasonable use, or
neglect
•Damage caused by an act of God
•Damage from failure to follow instructions contained in
the Owner’s Manual
•Damage from repairs performed by someone not autho-
rized by Aperion Audio
•Any unit on which the serial number has been effaced,
modified, or removed
•Damage occurring during shipment, other than that ar-
ranged by Aperion Audio
•Units which have been altered or modified in design,
appearance or construction
This warranty covers only the actual defects within the
products themselves. IT DOES NOT cover costs of installa-
tion in (or removal from) a fixed installation, or normal set-
up, claims based on any misrepresentation by the seller, or
performance variations resulting from installation related
circumstances such as signal quality, AC power or incom-
patibilities with other system components.
During the warranty period, Aperion Audio will, at its
option, either repair the defect, or replace the defective
product, or the defective parts, or components thereof with
the then current product/component in use by Aperion Au-
dio, at no charge to the owner for parts and labor covered
by this warranty. If necessary repairs are not covered by
this warranty, or if a unit is examined which is not in need
of repair, you will be charged for the repairs and/or the
examination.
If non-warranted repairs are needed, we will notify you of
the estimated cost and ask for your authorization to per-
form said repairs. You must pay shipping charges incurred
in getting your product to Aperion Audio. We will pay the
return shipping charges if the repairs are covered by the
warranty. Please save the original shipping cartons, as the
unit MUST be returned in the original carton and packing.
(Replacement cartons are available at a modest charge.)
Contact Us
If you have any questions, comments, or concerns,
please don’t hesitate to contact us.
www.aperionaudio.com
[email protected]
[email protected]
Aperion Audio Forum:
http://www.aperionaudio.com/community/forums/
Frequently Asked Questions (FAQ)
http://www.aperionaudio.com/catalog/Help,7.aspx
Aperion University
http://www.aperionaudio.com/catalog/Aperion-University,2.aspx
1.888.880.8992
18151 SW Boones Ferry Road
Portland, OR. 97224