Applied Motion Products STM23 User manual

STM23 Quick Setup Guide
Requirements
A small at blade screwdriver for tightening the connectors (included).▪
A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7.▪
ST Congurator™▪ software (available at www.applied-motion.com).
For RS-232 models: an Applied Motion programming cable (included)▪
For RS-485 models: an RS-422 or RS-485 port or adapter for your PC (see reverse for recommended RS-485 adapter)▪
For more detailed information, please download and read the ▪STM23 Hardware Man-
ual, available at www.applied-motion.com/support/manuals.
To begin, make sure you have the following equipment:
Step 1
Download and install the a) ST Congurator™ software.
Launch the software by clicking: b)
Start / Programs / Applied Motion Products / ST Congurator
Connect the drive to your PC using the RS-232 programming cable c)
or RS-422/485 adaptor
Step 2
Wire the drive to the DC power source.
(do not apply power until all connections to the drive have been made)
Note, the STM23 accepts DC voltages from 12-70V.
If using an external fuse, we recommend the following:
STM23: 3AG, 4 amp (Littlefuse 313004P)
See the STM23 hardware manual for more information about
power supply and fuse selection.
+
-
STEP+
STEP-
DIR+
DIR-
EN+
EN-
OUT+
OUT-
+5V
AIN
GND
920-0020 C

Step 3
If you have any questions or comments, please call Applied Motion Products Customer Support:
[phone], or visit us online at www.applied-motion.com.
404 Westridge Dr.
Watsonville, CA 95076
Tel: [phone]
Fax: [phone]
Apply power to the drive.a)
Follow the conguration instructions in the b) ST Congurator™ help screens.
The ST Congurator™ software can be used to set up your drive to operate in
several different modes including: Pulse & Direction, Analog Velocity,
and SCL.
920-0020 C
STM23 Quick Setup Guide
Recommended RS-485 Adapter
USB-COMi-M (P/N 8500-003)
Available from Applied Motion Products▪
Converts RS-422 and RS-485 to USB▪
For four wire RS-485, set SW2 to OFF and SW1,3,4 to ON.
On the USB-COMi-M screw terminal connector:
Connect pin 1 to RX-▪
Connect pin 2 to RX+▪
Connect pin 3 to TX+▪
Connect pin 4 to TX-▪
Connect pin 6 to GND▪
The DB-9 connector is not used▪
1
ON 2 3 4
4 Wire
RS-485