Aqara SSM-U02 User manual

Aqara Single Switch Module T1 (No Neutral) is based on the Zigbee 3.0 wireless
work with other Aqara smart devices to realize more smart scenes.
* This device requires a compatible Zigbee 3.0 hub.
Connect to Network
Indicator Light
Button
Antenna
01

1.
2.
3.
4.
6.
7.
9.
Do not cover when the plug is working.
Do not connect in series.
Do NOT use in humid environments or outdoors.
Do NOT place this product near a heat source. Do NOT place it in an enclosure
losses.
02

1.
installation!
Method 1: L1 is connected to the load wire. S0 and S1 are connected to the two
03

connected to S0, and the other end is connected to the live wire. L is connected to
the original switch, which is connected to the load wire, can be connected to S0 to
Diagram 1
04

Diagram 2 Diagram 3

2.
3.
touch it, and replace or repair it in time.
06

1.
app downloaded and the Aqara Hub installed.
4. Turn on the main power switch, and press the button on the module or on the
on the ceiling or inside the lights, the antenna should avoid too much shielding.
damaged.
07

2. Please open the app, tap “Home” and then tap “+” in the top right corner to
Neutral)”, and add it according to instructions.
Indicator Light Status Status Description
Device power on
Zigbee network is connecting
Blue light keeps on

Dimensions: 42.9 × 40 × 21.4 mm
Online Customer Service: www.aqara.com/support
Zigbee network is not connected
09

http://www.aqara.com/DoC/
10