Aqua Creek Products F-004AB User manual

Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/12/16
2nd Battery
Instructions
9889 Garrymore Ln
Missoula, MT 59808
888-687-3552 | [phone]
www.aquacreek.com
PART #: F-004AB
MANDATORY
LEAVE THIS MANUAL WITH LIFT OWNER
Read and follow all instructions.
Lift safety can only be ensured if the lift is installed and
operated according to these instructions.
• NEVER permit children to play on or around the lift
• Do not allow children to use the lift without adult
supervision
• NEVER apply direct water pressure to the electronics
• NEVER use the lift with a dry pool
Check entire box and all packing materials for parts. Before beginning assembly, read the instruc-
tionsandidentifypartsusingtheguresandpartslistedinthisdocument.
It is critical that all parts be carefully inspected prior to installation. If any damage occurred in
transit,AquaCreekProducts,LLCmustbenotiedwithinthreedaysofreceiptofunit.
Proper installation cannot be overstressed, as an improper installation voids Aqua Creek’s war-
ranty and may affect the safety of the user.
READ CAREFULLY
1

Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/12/16
The lift comes with one 24V Battery and a wall charger unit. This kit includes a 2nd 24V Battery, which
allows one battery to be on the unit while the other is on the charger. To take full advantage of the
2nd battery; one battery should always be kept on the charger. This should ensure that if the battery
on the lift becomes depleted during use, a charged battery is always available.
F-004AB: 2ND Battery Instructions
PLUG INTO
AC OUTLET
ONE BATTERY
ON CHARGER
AT ALL TIMES
CHARGER
MOUNTED
ON WALL
BATTERY ON
THE LIFT CAN
BE SWAPPED W/
CHARGED 24V
BATTERY
AT ANY TIME
LIFT OUTLINE
To recharge the battery, simply grip the top of the battery and depress the clip on the back of the
battery. This will unclip the battery from the control box bracket and the battery can then be clipped
into the wall mount charger. When the charger is plugged in the green ON light will illuminate. When
the battery is correctly mounted to the charger, the orange CHARGE light will illuminate. When the
battery is fully charged, the CHARGE light will GO OFF and the battery is ready to use. The battery
charger will automatically shut o when the battery is fully charged, so the battery can stay on the
charger any time it is not being used.
2

Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/12/16
Battery Maintenance
1) RECHARGE THE BATTERY AS OFTEN AS POSSIBLE. The battery power unit is
a sealed lead acid battery pack. Frequent recharges will prolong the battery life
and maintain a high cold amperage capacity.
2) Do NOT expose the battery to freezing temperatures.
3) Do NOT expose the battery to prolonged periods of extreme heat or severe cold
temperatures.
4) Do NOT expose the battery to long periods of direct sunlight. Heat will shorten
your battery life. Optimum operating temperature is below 20 degrees Celsius
(68 degrees F.)
5) Never drop or bump the battery pack.This may result in loose or damaged internal
connections, and may bend the battery terminals.
6) Keep battery terminals clean and free from dirt and corrosion to ensure good
contact. The terminals may be cleaned using Scotch Brite or any similar product.
Clean o any corrosion or discoloration on the very top surfaces of the battery
contacts and then apply dielectric grease (supplied with lift) as shown in the
gure below.
TAB TO
FRONT
HANDSET
CABLE
MOTOR
POWER
CABLE
1 2
MAKE SURE
PLUGS ARE
FULLY SEATED
AS SHOWN
BELOW
CLEAN WITH
SCOTCH-BRITE PAD
AND APPLY
DIELECTRIC
GREASE TO
TERMINALS
3