Aqua-Hot WORK READY WR20000 User manual

( -)
( -)
Medium/Moyen
High/Haut
( -)
( -)
Medium/Moyen
High/Haut
I – C2 - 092214
Figure 1: Front View
Power Source
WORK READY™ Auxiliary Heater
Model WR20000 | Part No. EXE-100-003
Low/ Basse
Low/ Basse
Heated fluid flows out through
coolant hose from heat exchanger
to radiator
Fluid flows in through input coolant
hose from engine to lower barb
Figure 2A: Back View with mounting tabs on bottom.
Figure 2B: Back View with mounting
tabs on top.
Heated fluid flows out through
coolant hose from heat exchanger
to radiator
Fluid flows in through input
coolant hose from engine to lower
barb
Figure 3: Three
Speed Fan Switch
(sold separately)

I – C2 - 092214
Installation
1.
Mount Auxiliary Heater (Heat Exchanger).
Ensure that there is enough clearance for two ¾” hoses to be
connected to the barbs on the back of the heat exchanger. If the hoses are being run through the floor,
firewall, or any other surface that requires drilling, make sure clearance is available on both sides of the
mounting surface before drilling.
Note:
Mounting hardware is NOT included.
2.
Plumb Auxiliary Heater (Heat Exchanger).
a. If mounted with mounting tabs on bottom (Figure 2A): Connect input coolant hose from vehicle engine
to lower barb on heat exchanger. Then connect output coolant hose from top barb of heat exchanger
to radiator.
b. If mounted with mounting tabs on top (Figure 2B): Connect input coolant hose from vehicle engine to
lower barb on heat exchanger. Then connect output coolant hose from upper barb of heat exchanger
to radiator.
Note:
Input coolant hose must always be connected to lower barb regardless of mounting.
Output coolant hose must always be connected to upper barb regardless of mounting.
3.
Connect wires of Auxiliary Heater (Heat Exchanger). Note:
It is recommended to install an inline fuse holder
with a 5amp fuse. (Sold by Aqua-Hot: Fuse Holder Part No. ELX-200-130, 5 amp Fuse Part No. ELX-200-140).
Three speed fan switch sold separately (Sold by Aqua-Hot: Part No. ELX-100-001).
a. Connect yellow wire from the heat exchanger to the “Low” (L) tab on three speed fan switch (Figure 3).
b. Connect orange wire from the heat exchanger to the “Medium” (M) tab on three speed fan switch
(Figure 3).
c. Connect red wire from the heat exchanger to the “High” (H) tab on three speed fan switch (Figure 3).
d. Connect vehicle power source to the “Battery In” (B) tab on three speed fan switch (Figure 3).
e. Connect both black ground ( - ) wires from the heat exchanger