Aqua One AquaStyle 620 User manual

Inspiring Excellence in Fish Care!
AquaStyle 380 510
620 620T 850 980 980T
9
Hints & Tips For Best Results
LIVE PLANTS
Once the water conditions and pH levels have
been corrected, live plants can be added to the
aquarium. Remember to empty some water from
the aquarium before adding anything to it.
REMEMBER LIVE PLANTS NEED TO BE FED!
An aquarium safe plant fertiliser should be used.
LIGHTING
It is recommended that the light is turned
completely off for at least 8 hours per day to allow
the sh a proper night period. More than 10 hours
of full light daily can encourage excessive algae
growth.
• The LED light unit does not require replacement
bulbs and should last the life of the tank.
• To maximise light quality, ensure that the clear
cover is kept clean.
FILTER MEDIA
Biological Filtration (Ceramic Noodles)
Biological ltration is a process where toxic
nitrogen compounds such as ammonia and nitrite
(Fish waste) are removed from the system via
a breakdown process carried out by nitrifying
bacteria. (Nitrobacter and Nitrosomonas). These
nitrifying bacteria need substrate with a high
surface area to adhere to such as Ceramic
Noodles.
• When starting a new system it is important to
remember that bacteria takes time to develop and
grow.
• You can speed up the process by ‘seeding’ the
system with Aqua One Bio Starter.
• Over time this media can block up or break down
so it is important to monitor it.
Seek advice from your Aquarium Specialist if
either of these problems arise.
Mechanical/Chemical Filtration (Carbon
Cartridge)
This is the removal of dissolved organic and
inorganic substances through adsorption on a
porous substrate or by direct chemical removal.
Dissolved organic compounds are what turns the
water a yellow-brown colour or causes foaming
at the surface of the aquarium and need to be
removed.
• Remove carbon cartridge if treating sh with
medication.
• Replace every 6 – 8 weeks as the carbons
absorption capacity will have depleted.
• Rinse well before placing in the aquarium. (in tap
water)
Mechanical/Biological Filtration (Filter
Sponge)
This is the process whereby suspended solids or
particulate matter are removed from the water.
It is important to remove suspended solids not
only to improve clarity of the water but also to:
• Avoid smothering the gills with solids such that
sh cannot breathe.
• Decrease risk of disease outbreaks - there
are high numbers of bacteria associated with
suspended organic solids.
• Protect the biological lter material from rapidly
becoming clogged.
• Can also act as a biological lter medium by
providing sufcient surface area to host benecial
bacteria
Note: This is only a guide! You should seek
professional advice from your aquarium specialist
at the time of purchase.
DO NOT ADD ALL FISH AT ONCE!
Build stock levels slowly over time. Allow at least
one week between additions of sh. Add a lter
supplement to help the biological system cope
with the additional waste.
Do not over crowd. Remember all sh will grow,
so allow them adequate space.
Introduction of Fish

Inspiring Excellence in Fish Care!
AquaStyle 380 510
620 620T 850 980 980T
10
Specications
If you are in any doubt about the electrical
installation or safety of this product you must
consult a qualied electrician.
LIGHT UNIT DOES NOT WORK
1. Ensure that the light switch is in an on position.
2. Check light is plugged into power supply and
the switch is on.
POWER HEAD WORKING BUT NO / SLOW
WATER FLOW
1. Check impeller is in good condition and replace
if needed.
2. Make sure water level in aquarium is above
the power head. Please note the power head is a
water proof unit.
3. Clean impeller, power head and all inlet and
outlet pipes.
4. Check that the spray bar is inserted correctly with
the end cap at the opposite end to the elbow.
AQUARIUM POSSIBLY LEAKING
1. Clean carbon cartridge as this can create an
overow.
2. Make sure spray bar holes are pointed down
onto the carbon cartridge.
3. Make sure water level is not to high (Refer to
page 6.)
4. If an air stone is being used check it is not
bubbling water over the rim of the aquarium if so
turn the air pump down.
Trouble Shooting
5. Make sure the aquarium is sitting on a level
surface.
6a. Remove the light unit & lter unit from the top
of the aquarium. Mark the water level. Remove
any excess water that may be sitting on the edge
of the aquarium. Leave for an hour. If water level
drops proceed to step 6b.
6b. Remove the sh, decorations and gravel.
Empty the aquarium and clean the glass DO
NOT WASH IN SOAP OR DETERGENT. Place
a piece of newspaper on a at level solid surface.
Carefully ll the aquarium ensuring not to spill any
water on to the newspaper. Leave the aquarium
for several hours and then inspect the newspaper
for wet patches.
Correct Disposal of this product
This marking indicates that this product should not be disposed
with other household waste throughout the EU. To prevent harm
to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use
the return and collection systems or contact the retailer where
the product was purchased. They can take this product for
environmental safe recycling.
Aquarium Model: AquaStyle 620
Dimensions: 62 x 52 x 39cm (5mm glass)
Aquarium Volume: 90L
Filter Flow Rate: 550l/hr
Light Wattage: 12.8W
Power Requirements: 220 ~ 240V AC
Suitable: Coldwater, Tropical
Aquarium Model: AquaStyle 620T
Dimensions: 62 x 72 x 39cm (5mm glass)
Aquarium Volume: 130L
Filter Flow Rate: 550l/hr
Light Wattage: 12.8W
Power Requirements: 220 ~ 240V AC
Suitable: Coldwater, Tropical