The power supply must meet the specification of the product.
Inpond Pump & UVC
The electric cables are permanently connected and sealed in the motor body and UVC
lamp holder. If the supply cable of the pump or UVC is damaged, the part must not be used
The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped
Do not use the supply cable of the pump or UVC to lift the filter as this may cause damage.
For permanent installations to the mains supply, it is necessary to conform to the regulations
of the local electricity authority ad this would include the use of a metal or plastic conduit to
protect the cable.
Attention has been drawn to the fact that special rules may exist concerning the installation
of your pond pump and UVC (i.e. local building regulations).
These pump and UVC units must not be used in swimming pools or areas where people are
in contact with the water.
Always disconnect the mains electricity supply whilst the equipment is being installed,
repaired, maintained or handled. Consult a qualified electrician if in any doubt about wiring
this product to the main supply.
WARNING - All Inpond models must be used with an RCD
A Residual Current Device (RCD), also known as the Residual Current Circuit
Breaker (RCCB), with a tripping current not exceeding 30mA must be installed
in the supply circuit.
A means of disconnection from the supply having a separation of at least
3mm in all poles must be incorporated in the fixed wiring.
Warning - The inpond pump is provided with a thermal cut out that
temporarily switches of the pump in case of overheating and the pump may
automatically restart.
UVC warning – Dangerous Ultra Violet Radiation. The rays from the UVC lamp
are harmful to eyes and skin.
Always turn off the UVC electrical supply before any maintenance.
To protect the UVC starter, never immerse in water. Locate the UVC starter
a minimum of 1 metre from the pond edge.
ELECTRICAL INSTALLATION
5
EN
