AquaScape Economy Foam Gun Applicator Instructions for use

ECONOMY FOAM
GUN APPLICATOR
Economy Foam Gun Applicator
Item #54003
aquascapeinc.com
INSTRUCTIONS & MAINTENANCE

☎
US [phone] |
☎
CAN [phone] |aquascapeinc.com
Instructions
STEP 1
• Before putting a can of foam on the gun, press the trigger
down to release any air trapped in the barrel.
STEP 2
• Shake foam can and thread the can into the gun.
NOTE: do not overtighten.
STEP 3
• Squeeze trigger to allow foam to fill the barrel.
STEP 4
• Adjust the flow by tightening or loosening the flow-
adjustment screw found on the back of the gun.
STEP 5
• For best results, mist the area to be foamed with water first.
STEP 6
• When finished, tighten the flow-adjustment screw fully until
trigger is locked.
General Maintenance
• Nozzle tip can be cleaned using a wire brush or similar
material. DO NOT scrape on rough surface such as
concrete or rocks.
• If the gun barrel is clogged, use a can of Foam Gun Cleaner
(Item #22011) to flush out the barrel.
• If the ball valve, located in the gun where the can is
attached, becomes stuck, use a thin object such as a
pencil, to press down on the ball to release.
For more information about our company or products, please visit our website at aquascapeinc.com
or call us at US [phone]or CAN [phone]
©2018 Aquascape, Inc. • All Worldwide Rights Reserved
04/18
WARNING: Always keep a can of
foam on the gun. Failure to do so
will cause foam to harden in the
barrel and clog the gun.