Set your new Admin PIN:
Scratch off the holographic label that reveals the temporary password
Sign in to Admin mode
Press and hold the Unlock (green button) and 0 (zero) at the same time for 5 seconds
Enter the temporary admin PIN then press Unlock
Replace the admin PIN
Press and hold the Unlock and 9 (nine)
Enter your new admin PIN then press Unlock
Re-enter your new admin PIN then press Unlock
Creating a Self-Destruct PIN: Use with caution
Press and hold the Unlock (green button) and 3 (three) at the same time for 5 seconds
Enter your Self-Destruct PIN then press Unlock
Re-enter your Self-Destruct PIN then press Unlock
Note: The Self-Destruct PIN cannot be the same as the Admin PIN.
Set unattended auto-lock:
Once in Admin mode - Press and hold the Unlock and 6 (six)
Press one of the numbers below that corresponds to the amount of inactivity you would like the device to lock:
0 = OFF (The Default is OFF for this feature.)
1 = 5 minutes
2 = 10 minutes
3 = 20 minutes
Best Practices | USB Safety Tips
Enter The PIN before inserting the USB into its slot. Do not enter the PIN while the device is connected.
Close all applications before hibernating, suspending, logging off or ejecting the USB device. This is an important step especially if
you are using the A55 Key Quest Vault or a software cryptocurrency wallet.
Put the USB Device back in its capsule when not in use. You should remember to seal the capsule and store it in a safe place.
Make sure your are not being watched or recorded by a surveillance camera. Be aware of your surroundings and look behind you.
Do not plug the USB into a suspicious computer. Avoid using a computer that may be infected with malware.