Clare Controls ClareOne CLR-C1-PNC Assembly instructions

© 28MAY20 Clare Controls, LLC. 1 / 3 DOC ID –1926 • Rev 03
ClareOne Panic Pendant (Keyfob)
Installation Sheet
Part number: CLR-C1-PNC
Description
The ClareOne Panic Pendant (Keyfob) is a lithium battery
operated wireless handheld panic device for the ClareOne
Panel system. When the button is pressed, a wireless signal is
sent to the panel, setting the panel to Panic.
Notes
•The ClareOne Panel must be monitored for the panel’s
panic state to be received at a call station.
•Non-supervised sensors should be tested once a week,
ensuring proper function.
Important safety instructions
Before you program this sensor, be sure to:
•Read, keep, and follow all instructions.
•When there is a low battery, replace with a compatible
lithium ion battery within 7 days.
Setup
Use the ClareOne panel to add the panic pendant.
To add the pedant to the panel:
1. Add the sensor to the panel. See “Sensor Management.”
ClareOne User Guide (DOC ID 1871).
2. Once added, test the sensor.
Look at the ClareOne panel, and then press the panic
button.
Notice that the panel enters an alarmed state.
Note: Testing all sensors to the alarm monitoring station
is strongly advised.
Button function
The pendant has 1 button. Once the pendant is added to the
panel, pressing the button sends a wireless alert to the panel.
This alert sets the panel to Panic. If the ClareOne Panel has a
monitoring service, the alarm monitoring station is notified.
Battery replacement
The ClareOne Panic Pendant requires a CR2032 battery.
When the battery is low, the panel displays a low battery icon
next to the sensor in the devices list. The battery must be
replaced within 7 days of the first low battery notification. If the
battery is not replaced within 7 days, the sensor may not
function properly.
Note: Regular battery maintenance is important, see your
battery manufacturer for recommended battery replacement
frequency.
WARNING: If an incompatible replacement battery is used, or
the battery is installed incorrectly explosion or damages may
occur.
AVERTISSEMENT: Si une batterie de remplacement
incompatible est utilisée ou si la batterie est installée de
manière incorrecte, une explosion ou des dommages peuvent
survenir.
To replace the battery:
Note: Verify that the panel is not armed before changing the
battery.
1. Hold the panic pendant firmly in one hand.
2. Slide both thumbnails in the side indent, and then pull the
sides away from each other.

2 / 3 DOC ID –1926 • Rev 03
Note: The keyring keeps the 2 pendant pieces connected.
3. Use a fingernail/fingertip to push the battery out of the
casing, noting the polarity of the battery.
4. Slide a new CR2032 battery into the battery casing,
making sure that the polarity is correct.
5. Press the pendant backplate into place.
6. Test the sensor.
Specifications
Compatible panel
ClareOne
Transmitter frequency
433MHz
Encrypted
Yes
Transmitter indications
Low battery
Visual indications
LED light
Battery type
CR2032
Battery life
4 to 5 years
Operating environment
Temperature
Relative humidity
32 to 120°F (0 to 49°C)
95% non-condensing
Dimensions
2.25 × 1.25 in.
(57.15 × 32.75 mm)
Water resistant
No
Certifications
FCC: 15.109 Class B 15.231, Industry
Canada: ICES-003, RSS-210, ETL listed to
UL-1023 and ULC-C1023
Regulatory information
Manufacturer
Clare Controls, Llc.
7519 Pennsylvania Ave, Suite 104
Sarasota, FL 34243
North American
standards
ETL listed to: UL 1023, ULC 1023
FCC compliance
FCC ID: 2AVDC-XPD-201
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the
equipment and receiver.
-- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
Warning: changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20 cm
between the radiator and your body.
Environmental
class
UL: Indoor dry
IEC: 3K5
EU compliance
EN 54
EN 54-00:0000
European Union
directives
1999/5/EC (R&TTE directive): Hereby, UTC Fire
& Security declares that this device is in
compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.

DOC ID - 1926 • Rev 03 3 / 3
2004/108/EC (EMC directive): Hereby, Clare
Controls, Llc. Declares that this device is in
compliance with the essential requirements and
other relevant provisions of Directive
2004/108/EC.
2002/96/EC (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.recyclethis.info.
2006/66/EC (battery directive): This product
contains a battery that cannot be disposed of as
unsorted municipal waste in the European Union.
See the product documentation for specific
battery information. The battery is marked with
this symbol, which may include lettering to
indicate cadmium (Cd), lead (Pb), or mercury
(Hg). For proper recycling, return the battery to
your supplier or to a designated collection point.
For more information see: www.recyclethis.info.
Warranty information
Clare Controls offers a two (2) year limited warranty on original
Clare Controls components, from the date of shipment from
Clare Controls.
Contact information
Clare Controls, LLC.
7519 Pennsylvania Ave, Suite 104
Sarasota, FL 34243
General: 941.328.3991
Fax: [phone]
www.clarecontrols.com
Integrator/Dealer Support: 941.404.1072
[email protected]
Homeowners should contact their installation dealer for
assistance.
Scan the code to
view the full PDF
online.