ARCHITETTURA SONORA ICARUS WALL User manual

ICARUS_WALL
Unpacking: to remove Icarus_wall from the shipping box carefully follow these steps
Installation:
Speaker type
3,5” Wide Band
Nominal impedence
8 Ω
Crossover
DSP needed
Frequency range
100-20.000 Hz (-6dB)
Sensitivity (1W-1m)
86 dB/W/m
50W (Class D)
Material
concrete, marbles, travertine,
alternative stones.
Metal material
stainless steel, oxidized brass,
and painted steel
Dimensions
Weight
3 kg (6,6 pounds)
SPECIFICATIONS
SOUND OUTPUT
2.
Remove the metal nishing
disc and the metal plate with
holes and set them aside.
3.
Remove the upper part of
the foam to release the
sound module.
the installation of the Icarus_wall
requires two people, especially during the cable
connection phase.
Align the central hole of the metal plate with the hole
in the wall where the audio cable comes out and
using the plate as a template mark the three holes
with a pencil. Proceed to drill the holes and insert into
them the expansion wall plugs you will need to
secure the metal plate in the wall.
Connect the sound module cable to the cable
coming out from the wall using a cable connector.
The part of the cable with the connector will then be
housed in the space provided behind the metal plate,
so that the connection remains hidden towards the
wall (see section next page).
4.
Holding gently the module
pull it out of the box ready for
set-up and installation.
1.
Icarus_wall is shipped in a box
secured with packing foam; the
box has been designed to contain
up to two sound modules.
20 x 11,9 cm
(7,87 x 4.68 inches)
11,9cm
4.68”
10,9cm
4.30”
20,0cm
7.87”
15,2cm
5.98”
11,9cm
4.68”
1,6cm
0.24”
4,8cm
1.88”

Acoustic connectivity & settings:
the Icarus_wall necessarily requires an amplier equipped with DSP on
board. For everything concerning the regulation of the DSP, please refer to the website www.architetturasonora.com or to your speciali-
zed dealer.
Last update: February 2020
Specication could be changed without notice
to keep your speakers beautiful as long as possible, we warmly recommend doing maintenance at
least once a year. When not in use, sound modules should be appropriately covered or stored
away; heavy duty protective covers are available from AS.
Please refer to the General Manual for appropriate instructions and note that any departure from
our recommendations on care and cleaning, or any evidence of misuse or damages from ordinary
wear and tear, will void all warranty claims.
Maintenance and care:
Fix the plate to the wall by tightening the screws
into the expansion wall plugs.
Now you can screw the sound module’s threa-
ded end of the metal joint to the metal plate on
the wall; the nishing metal disc will cover the
heads of the screw.
Position the sound module in the desired
position by moving it around its spherical joint,
after loosening the mechanics with a 20 mm
wrench; tighten it back to hold desired position.
space for cable
connection
spherical
joint