User’s Manual – AREBOS Juice Extractor 800W
6
4. Service
- Make sure that the appliance is serviced only by specialist personnel, and that only original spare
parts or accessories are used to replace existing parts/accessories.
- Any misuse or failure to follow the instructions for use renders the guarantee and the
manufacturer’s liability null and void.
5. Instructions for use
5.1 Before use
- Make sure that all the product’s packaging has been removed.
- Before using the product for the first time, clean the parts that will come into contact with food in
the manner described in the cleaning section.
5.2 Use
- Unroll the cable completely before plugging it in.
- Make sure the filter (C) is well placed, turning and pressing down.
- Place the protective lid (B) in the correct position.
•Connect the appliance to the mains.
•Place the deposits of juice (F) and pulp (G) in the position.
•Once you have checked that the closing clamps (E) are well fitted.
•-Turn the appliance on, using the speed selector (I).
•-Note: If the all the parts are not correctly assembled, the appliance will not start.
•The illuminated ring (J) will be lighted.
•Choose desired speed: I (low speed) or II (normal speed).
•-Speed I is especially suitable for soft fruits and vegetables such as watermelons, grapes,
tomatoes, cucumbers…
•-Speed II is suitable for all other kinds of fruits and vegetables such as apples, carrots…
•Insert the properly-cut fruit or vegetables into the corresponding opening in the protective
lid
•Squeeze it gently with the pusher.
•The juice and the residual pulp will automatically separate out: the juice into the glass (F) and
the residual pulp into the pulp collector (G).
•Do not exert too much pressure on the pusher as it could affect the quality of the end result.
It could even cause the filter come to a halt.
•Do not use the appliance for more than 3 minutes at any one time. Stop the motor and allow
it to cool for at least 2 minutes. Otherwise the motor may become damaged.
•Once finished, leave the motor to run a few seconds so that the juice can be strained.
•Stop the appliance, selecting position 0 on the selector control. (I)
•Before opening the blender, ensure that the motor has stopped completely.
•Open the two closing clamps (E).
•Remove the deposits of juice (F) and pulp (G), the pusher (A) and the protective lid.
•First pull the filter (C) and then the upper body (D).
•Remark: If you process a large quantity of fruit, you must periodically clean the filter and
remove the remains of the pulp.
