Arlec LVS210 User manual

RIGHT READ DYELINE
LVS210 – CPCD002981
(50mmW x 65mmD)
BACK FRONT
© This packaging is subject to copyright
and must not be reproduced, copied
or otherwise used in any way or for any
purpose without the consent in writing
of the owner, Arlec Australia Pty Ltd
(ACN 009 322 105).
Visit us at www.arlec.com.au
Made in China CPCD002981
P
O
W
E
R
E
D
B
Y
S
U
N
L
I
G
H
T
C
O
S
T
E
F
F
I
C
I
E
N
T
SOLAR
L
O
N
G
L
I
F
E
T
E
C
H
N
O
L
G
Y
E
N
E
R
G
Y
S
A
V
I
N
G
WHITE
LED
QUALITY
STAINLESS
STEEL
Glitter
LED SoLar
GarDEn LiGht
With Silver Mosaic Lens
LVS210

RIGHT READ DYELINE
LVS210 – CPCD002981
(50mmW x 65mmD)
LEFT INSIDE RIGHT INSIDE
inStaLLation
1.
Slide the switch to ON position
as shown in the figure below.
2. Insert garden stake into the bottom
of the support tube.
3. Insert stake into ground in position.
Adjust the solar panel housing so as to
receive the maximum sunlight, thus
assisting in adequate charging. Ensure
that the light is not positioned close to
another night time light source.
important information
Battery will require charging before
first use. Once charged, the light
will turn on automatically when the
light level dims.
It may take a
few days of
good sunlight to
achieve optimum
performance. On
cloudy days, the
charge from the
solar panel will
be reduced with
corresponding
reduction in
brightness and
length of operation.
380mm
720mm
95mm
ON/OFF Switch Garden Stake