ARM KEIL MCB1700 User manual

Copyright © 2015 ARM Ltd. All rights reserved.
Quick Start Guide
MCB1700 –NXP LPC1700
Install Keil MDK Version 5
Download and install the MDK Core from www.keil.com/mdk5/install
Add Software Pack using the Pack Installer
Keil::LPC1700_DFP –NXP LPC1700 Series Device Support
Power up the board
Connect a USB power supply to the Power receptacle
Connect the board to the PC using the Trace Connector and a debug adapter, for example ULINKpro
Verify Installation using example projects provided in the Software Pack or download examples that apply to
this board www.keil.com/dd2/nxp/lpc1788
Copy an example using the Pack Installer. Compile, download to Flash, and debug the application. The
provided examples are ready to run. Trace settings might have to be adapted.
More Information
Evaluation Board Description www.keil.com/boards2/keil/mcb1700
MCB1700 User’s Guide www.keil.com/support/man/docs/mcb1700
Related Information
MDK Version 5 www.keil.com/mdk5
Getting Started User’s Guide www.keil.com/gsg
MDK-Professional Middleware www.keil.com/middleware
Learning Platform www.keil.com/learn

Copyright © 2015 ARM Ltd. All rights reserved.
Debug and Trace Configuration
MCB1700 –NXP LPC100
ULINKpro Debugger and Trace Adapter
In the dialog Options for Target –Debug enable Use and select ULINK Pro Cortex Debugger.
Click on Settings.
Switch to the Pack tab and check
Enable to activate the Debug
Description.
Switch to the Debug tab and ensure that Port is set to SW for Serial Wire Debug.
You may adjust the Max Clock to the desired debug speed.
Trace Settings
For full trace capability, switch to the
Trace tab, enter the correct CPU
Core Clock speed as specified in your
project and check Trace Enable.
Set Trace Port to
Sync Trace Port with 4-bit Data.
Set the clock delay time for data pins
CLK to 4.9ns. Leave the individual
delay times at zero.
Complete trace configuration instructions for this board can be found on the web page
www.keil.com/mdk5/ulink/ulinkpro.Choose ULINKpro User’s Guide in the Quick Links and continue with
the chapter Configure Cortex-M Devices for Tracing.Select chapter NXP LPC17xx Devices and then
Enable 4-Pin Trace (ETM).