ASC Woodland Waterfall SF015 User manual

1
SF015 Solar Woodland Waterfall Instructions
By All Solar Central
www.allsolarcentral.com
Thank you from the entire ASC family for urchasing
an ASC solar roduct! Please read this entire booklet
before assembly.
Package contents:
1 x Woodland Waterfall
1 x Door Cover
1 x Water Pum
1 x Solar Panel
1 x Solar Panel Bracket
1 x Extension Tube
1 x Ground S ike
Notes: If there is any damage to the roduct or missing
arts, lease contact us at 1-626-582-8898 or
www.allsolarcentral.com/contactus
Assembly Steps:
1. Place your new fountain to a desirable lace.
2. Attach the um to the hose from access anel
on the back of the Woodland Water Fall
Fountain. The um cable exists from the back
access anel.
3. Fill the fountain with a ro riate amount of
water to fully submerse the um .
4. Connect the bracket, tubes and s ike together.
Then attach the solar anel to the bracket. Slide
the holding bracket into the inside li of the to
half of the solar anel frame. The bracket holds
the weight of the solar anel. The solar anel can
be adjusted for o timal sunlight by using the
wingnut. Please see the diagram.

2
5. Insert the s ike into the ground. Position the
solar anel so it’s facing south (in northern
hemis here) as much as ossible to maximize
daylight hours. It is im ortant to angle the solar
anel to face the sun when the sun is at its
highest oint. Ensure the solar anel is not
shaded by trees, shrubs or buildings.
6. Connect the Pum to the back side of the Solar
Panel. IMPORTANT!! Slightly twist the connectors
when connecting to make sure the rubber seals
are fully in the grooves.
Notes: Pum Kits might vary. Please refer to the
Solar Water Pum Kit Instructions for more
information.
7. Now your new fountain is assembled and ready
to use.
Please visit www.allsolarcentral.com for more
roducts and offers.