Twist and unlock the endcap
as shown
Line up the white raised mark
and black indented mark
Remove the endcap
Place the protective cap that you
saved onto a at surface. Push the
lancet into the cap as shown
Rotate the endcap dial to adjust
the puncture depth
1 for the shallowest and
5 for the deepest
Lancing Device
™
Steps to lancing success
Press the lancing device firmly
against the side of your finger and
press the release button
You will hear a click when the
lancet is released
Push the grey lancet ejector
forward until the lancet falls into
the container, then slide ejector back
Don’t forget to re-attach the endcap
Loosen the round protective cap
on the lancet but do not remove it
Rotate 1/4 turn
Insert the lancet firmly into the
lancing device
Push until the lancet comes
to a complete stop
Carefully twist off the round
protective cap
Save the cap for disposing of
the used lancet
Re-attach the endcap
‘Click’ to lock
Pull back the reset handle until
the release button is raised
Before use and for full information please see the MICROLET™NEXT packaging insert1
Prepare Lance
Eject
1. MICROLET™NEXT insert.
1 2
3
