Aspire SkyStar Revvo Set User manual

Aspire SkyStar Revvo Kit
(210W 3.6ML 0.10/016ohm)
Aspire brings you yet another great new mod and tank kit. Introducing the even
more powerful, more up to date, SkyStar Revvo kit. It’s a dual 18650, 210-watt
mod with a 1.3-inch touch screen and the revolutionary Revvo tank. Aspire has
broken the mold for a tank of this type and brings you an all-new concept in
coils, the flat Radial coil. A coil for great vapor production and excellent flavor.
The tank itself comes in a TPD compliant 2ml version and a standard 3.6ml
version. It has adjustable top airflow and is top fill, it is simplicity itself to fill,
change coils and even replace the glass.

The tank comes in a TPD compliant 2ml version and a standard 3.6ml version.

The Revvo tank is almost too easy to maintain, to disassemble and reassemble
is merely unscrewing or screwing the various parts, the coil can be changed
even when there is liquid in the tank.

No one has yet produced such an innovative replaceable coil for a tank until
now, except, of course, Aspire. The fantastic all-new coil design, the ARC,
“Aspire Radial Coil” which sits horizontally in the tank similar to a “stove-top”
design. Of course, the real trick in the design is the increased surface area of the
coil for great flavor and great vapor production, made using Kanthal wire, and
rated at 0.10ohm – 0.16ohm.

The tank has adjustable top airflow with three large air inlets to enable full
enjoyment of your favorite e-liquids.

Filling your new Revvo through the center of the tank, in which sits a spring-
loaded filling tube. The spring of the tube is soft enough to allow even slight
pressure from almost any type of bottle/glass dropper to open it, but strong
enough to create a leak-proof seal when released after filling.

Battery installation is almost foolproof, inside there are clearly marked battery
orientation markings (+ and -) and of course, a securely mounted battery removal
tape. When inserting the batteries, turn off the mod. Open the back panel by
inserting a fingernail into the slot at the bottom and pull off the battery cover.
While the mod is on, swipe down the screen twice will take the mod into its
menu interface, where you can adjust the settings to your liking: modes, data,
system, time, about.

The Skystar can also be charged via the Micro-USB port. When charging the
screen will display a flashing battery icon, voltage level, charge current as well
as charge time. The charging port can also be used to update the firmware.