Assa Abloy SafeZone Remote Operating instructions

Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited. 80-9371-0001-000 (01-14)
Unlock
Lock
Immunity
Immunity helps to reduce the chance of
unwanted detections due to environmental
disturbances.
1 = Reduced
2 = Normal
3 = Increased
4 through 9: enhanced immunity (for highly
reflective environment)
Hold Time
0 = 0.5 sec.
9 = 20 sec
Default: 5 = 10 sec
Sensitivity
0 = Minimum Sensitivity
9 = Maximum Sensitivity
Default: 8
NOTE: Every adjustment, when using the
infrared remote control, must start with
the unlocking function, and end with the
locking function.
The amount of time door will be held open after
movement is not detected in the opening. Values
range from 0 to 9.
Default: 2
Detection Mode
Detection mode offers 3 different levels of
detection:
1 = Bi-Directional
2 = Uni-Directional
3 = Uni-Directional with motion tracking feature
Default: 1
Door Control Mode (F2)
1 = Safe Zone
2 = Infinite Hold Open
3 = Detection Off
Default: 1
To UNLOCK the sensor:
Press the UNLOCK key once.
To LOCK the sensor:
Press the LOCK key twice.
Example: Set Safe Zone to hold open 9
seconds after movement is not detected in
the opening.
Step 1 - Press unlock ; LED flashes
Step 2 - Press time ; LED flashes quickly
Step 3 - Press 9 ; LED flashes
Step 4 - Press lock ; LED flashes quickly
Step 5 - Press lock again to save setting;
LED does not flash
®
SafeZone Remote
Programming Guide
DOOR CONTROL MODE:
SafeZone - holds door open as long as movement is detected in the opening.
Infinite Hold Open - door held open constantly (with or without movement being detected).
Detection Off - standard door closer operation; open and close/no hold open.

Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited. 80-9371-0001-000 (01-14)
SafeZone is equipped with a Motion Tracking Feature (MTF). The MTF is available when SafeZone is used in the uni-directional
mode. SafeZone is factory preset with the MTF ON. MTF is recommended for use in short vestibule areas to help reduce unwanted
door hold-open time. Refer to the Programming Guide to alter this setting. It is recommended that the MTF be enabled for all
applications. The detection capabilities perform as follows:
BI-DIRECTIONAL MODE:
• Detection of all motion towards or away from the sensor.
UNI-DIRECTIONAL MODE:
• The detector will work in a uni-directional mode at all times regardless of traffic patterns - detecting only motion moving
toward the sensor.
OR
UNI-DIRECTIONAL MODE WITH MTF: The principle is as follows:
• The detector does NOT activate its relay as long as it detects movement exclusively moving away from the detector. It
acts like the classic unidirectional detector.
• As soon as SafeZone detects movement toward the sensor, it automatically switches to bi-directional mode.
• SafeZone maintains the bi-directional function for approximately 2 seconds following the last detection of motion toward
the door.
• At the end of the 2-second time frame, if SafeZone does not detect any further motion, it switches back to the
unidirectional mode.
3000 Highway 74 East • Monroe, NC 28112
Tel: (877)- • Fax: [phone]-2255
www. no r to ndoorcontrols. co m
ASSA ABLOY