Astonica 50105609 User manual

110107rev1
Model No. 50105609
Nassau Sling Chaise Lounge
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.
Limited Warranty
World Factory, Inc.®Products for Home Use
World Factory, Inc.®(Seller) warrants to the original Buyer only, that each Astonica®Product will be
free from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE
SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY
FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc.®authorized service
center. Call 1-888-424-3354 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR
LOSS OF PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.
®
Made in China
©2006 World Factory, Inc.
Distributed by:
World Factory, Inc.
Coppell, TX 75019
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CONSUMER SUPPORT AT
1-888-424-3354
OR
IF YOU ARE A STORE MANAGER OR EMPLOYEE IN NEED OF ASSISTANCE CALL
1-888-851-5569
PLEASE HAVE YOUR STORE NUMBER READY
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-424-3354

ASSEMBLY INSTRUCTIONS
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
Figure 1
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A Seat  1
B Back 1
C Left Arm 1
D Right Arm 1
E Hex Head Bolts 8
F Allen®Bolts 2
G Lock Nut 2
H Plastic Hex Bolt Cap 8
I Metal Washers 12
J Plastic Spacers 2
K Plastic Allen® Bolt Cap 2
L Plastic Nut Cap 2
M Hex Key 1
N Open End Hex Wrench 1
Parts Detail
NOTE: This product is intended for residential, non-commercial use.
12
AA B
B
C
D
E
E
E
F
F
HK
H
H
I
I
I
I
I
J
J
L
L
M
K
G
G
N
C D
 CAUTION: Do not over tighten fasteners.
Install Chair Seat Frame
(SEE FIGURE 1)
1.Place left arm on a flat non-abrasive surface. Align the lounger seat (A) with left arm (C).
2.Attach lounger seat to front and rear of arm using hex head bolt (E) with metal washer (I).
3.Attach the seat to the right arm (D) using the same procedures as step 2.
4.Do not tighten fasteners.
Install Chair Back
(SEE FIGURE 1)
1.Align Back (B) with Seat Frame (A).
2.Attach the Back to the Seat Frame using Allen® bolt (F) with metal washer (I), Plastic Spacer (J)
 [between Seat (A) and Back (B)] and Lock Nut (G).
3.Turn lounger upright. Using hex key (M) and open end hex wrench (N) tighten all fasteners a few
 revolutions at a time in a cross corner pattern.
4.Cover all bolts and nuts with the plastic bolt and nut caps (H,K, L).
Your Chaise Lounger is now ready to use.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
C