Astral Pool CalidoRay User manual

28/02/2013
INSTALLATION AND
MAINTENANCE INSTRUCTIONS
Melbourne: 03 8796 8600 Gold Coast: 07 5552 2600 Perth: 08 9350 2600
Sydney: 02 9853 2100 Townsville: 07 4750 3100 [e-mail]
Brisbane: 07 3308 5400 Adelaide: 08 8152 7600 www.astralpool.com.au
Bolero ND
Cleaner
INSTALLATION AND OPERATING INSTRUCTIONS I INSTALLATION AND OPERATING INSTRUCTIONS
CalidoRay Underwater
Lighting
®Rainbow Pool Products
PO Box 2388, Mansfield Qld 4122
Telephone STD 61-7-3849 5385
Facsimile STD 61-7-3849 5384
Email: [email protected]
Web: www.rainbowpoolproducts.com.au

Inst294 CalidoRay Underwater Lights V12.11
2
INTRODUCTION
Congratulations! You have purchased a high quality CalidoRay underwater light manufactured for Astral Pool
Australia. Please read the instructions carefully and your purchase will provide you with years of trouble free use.
Note:
The appliance is not intended for use by young children or infirm person without supervision. Please ensure that
young children are supervised to ensure that they do not play with the appliance.
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall
be destroyed.
COMPONENTS INCLUDED
1 x CalidoRay Underwater Light (fitted with either LED or Xenon Lamp)
1 x Power Transformer
1 x Wall Conduit (if concrete model)
3 x Coloured lens
ELECTRICAL SPECIFICATIONS
Power Input: 230-240VAC, 50Hz
Power output: 12VAC
Current output: 4.2A
IP Rating: IP44

Inst294 CalidoRay Underwater Lights V12.11
3
INSTALLATION OF LIGHT (FIBREGLASS)
1. Locate position in pool that lights are to be mounted. The fitting should be performed to position the light
approximately 300mm below the water level of the pool during normal operation. Do not install lower than
430mm below pool edge otherwise cable will not be sufficient to bring light up to pool deck for lamp
replacement.
2. Using a hole saw, cut 60mm diameter hole at the light location. Once cut, clean hole to ensure no debris
or burrs are remaining.
3. Fit CalidoRay light through hole in pool shell ensuring rubber seal is on the water side of the pool shell.
Run a line of silicon around the hole on the outside of the pool shell then tighten nut up onto the thread of
the light body.
4. The light transformer has an IP44 rating which allows installation in Zone 2 of the pool area (a minimum of
2m from the waters edge). The transformer should be installed in a suitable position at least 1.2m above
ground level and in accordance with all local, state and national wiring standards.
5. Connect cable from light to light transformer. The transformer is not polarity sensitive and either wire can
be connected to either terminal.

Inst294 CalidoRay Underwater Lights V12.11
4
INSTALLATION OF LIGHT (CONCRETE)
1. Locate position in pool that lights are to be mounted. The fitting should be performed to position the light
approximately 300mm below the water level of the pool during normal operation. Do not install lower than
430mm below pool edge otherwise cable will not be sufficient to bring light up to pool deck for lamp
replacement.
2. Fit CalidoRay concrete wall conduit into steel work marking sure it is secure and will not move during
concrete pour. Ensure cap is fitted to conduit prior to concreting. Note: There are indicators on the side
of the conduit to guide depth inside the wall. It is important to have a minimum of 180mm from the
rear of the conduit to the front of the pool wall.
3. After concrete pour cut conduit flush to pool surface.
4. Fit light into wall conduit and glue into place prior to commencing pool surface finish.
5. The light transformer has an IP44 rating which allows installation in Zone 2 of the pool area (a minimum of
2m from the waters edge). The transformer should be installed in a suitable position at least 1.2m above
ground level and in accordance with all local, state and national wiring standards.
6. Connect cable from light to light transformer. The transformer is not polarity sensitive and either wire can
be connected to either terminal.
Inst294 CalidoRay Underwater Lights V12.11
5
REPLACEMENT OF LAMP (LED OR XENON)
1. Remove clip on lens from front of CalidoRay light. Grip front of light and turn in anti-clockwise direction to
remove light from the housing. Bring light up to above water level.
2. Undo screws from flexible lens ring and remove lens and ring.
3. Replace lamp ensuring no moisture is present inside the housing. It is important to replace the o’ring seal
each time the light housing is opened.
4. Replace lens and ring on front of light and tighten screws. (Ensure o’ring remains in place)
5. Feed cable back into light housing and tighten body into place by turning in a clockwise direction.

Inst294 CalidoRay Underwater Lights V12.11
6
WARRANTY –CALIDORAY LIGHTS
AstralPool Australia Pty Ltd (ABN 97 007 284 504) ("AstralPool") provides the following warranty in relation to
its CalidoRay under water lights.("Product").
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
The benefits of this warranty are in addition to any rights and remedies imposed by Australian State and
Federal legislation that cannot be excluded. Nothing in this warranty is to be interpreted as excluding,
restricting or modifying any State or Federal legislation applicable to the supply of goods and services which
cannot be excluded, restricted or modified.
WARRANTY
AstralPool warrants that, subject to the exclusions and limitations below, the Product will be free from defects
in materials and workmanship during the warranty period. The warranty periods are set out below and
commence 30 days after the date of purchase (to allow for installation). The warranty period may vary for
different parts of the Product.
Parts
Warranty Period
Transformer and molded parts
12 months
Lamp
3 months
If a defect appears in the Product before the end of the warranty period and AstralPool finds the Product to be
defective in materials or workmanship, AstralPool will, in its sole discretion, either:
(a) replace or repair the Product or the defective part of the Product free of charge; or
(b) Cause the Product or the defective part of the Product to be replaced or repaired by an Authorised
AstralPool Service Agent free of charge.
AstralPool reserves the right to replace defective parts of the Product with parts and components of similar
quality, grade and composition where an identical part or component is not available.
Goods presented for repair may be replaced by refurbished goods of the same type rather than being repaired.
Refurbished parts may be used to repair the goods.
WARRANTY CLAIMS
1. If a fault covered by warranty occurs, the customer must first contact AstralPool at the contact address
listed below, or an Authorised AstralPool Service Agent.
2. Any warranty claim must be accompanied by:
(a) proof of purchase;
(b) full details of the alleged defect; and
(c) appropriate documentation (such as historical and maintenance records).
3. The customer must make the Product available to AstralPool or its Authorised AstralPool Service Agent for
inspection and testing. AstralPool or its Authorised AstralPool Service Agent will attend the premises where
the Product is installed for inspection and testing. If the Product is installed:
(a) outside a capital city metropolitan area; and
(b) is not within a 20 km radius of an Authorised AstralPool Service Agent;
then the customer may have to pay a travel fee.

Inst294 CalidoRay Underwater Lights V12.11
7
4. If such inspection and testing finds no defect in the Product, the customer must pay AstralPool's usual
costs of service work and testing. If such inspection and testing finds a defect that is not covered by this
warranty, the customer must pay AstralPool's usual costs of service work plus any parts and labour required to
repair the Product, unless recoverable from AstralPool on the failure of any statutory guarantee under the ACL.
Exclusions
The warranty will not apply where:
(a) the customer is in breach of the Terms and Conditions of Sale;
(b) the Product was used for a purpose other than one it was intended for;
(c) the Product was repaired, modified or altered by any person other than AstralPool;
(d) the Product has not been installed, maintained and/or operated in complete compliance with the
installation and operating instructions and any instructions by AstralPool;
(e) the Product has been subject to accident, negligence, alteration, abuse or misuse.
The warranty does not extend to:
a) normal wear and tear;
b) weather and other environmental conditions including but not limited to storm, flood, and/or heat wave
damage; or
c) service and maintenance items.
Examples of exclusions include but are not limited to:
•water ingress to transfomer
•lamp failure
Commercial Installations
On commercial installations, such as health clubs, motels/hotels and hydrotherapy facilities, the warranty is
limited to parts and in field labour (within capital city metropolitan areas or 20 km radius of Authorised
AstralPool Service Agents) for a period of 12 months from the date of purchase plus 30 days to allow for
installation.
LIMITATIONS
AstralPool makes no express warranties or representations other than set out in this warranty.
The repair or replacement of the Product or part of the Product is the absolute limit of AstralPool's liability
under this express warranty.
®Rainbow Pool Products
PO Box 2388, Mansfield Qld 4122
Telephone STD 61-7-3849 5385
Facsimile STD 61-7-3849 5384
Email: [email protected]
Web: www.rainbowpoolproducts.com.au