
!WARNING
Avoid pinch points or crush points that can EH
FUHDWHGE\WKHORDGRUSDUWVRIUDP
To help prevent material IDWLJXH if the ram is to EH
used in a continuous application, the load should
QRWH[FHHGRIWKHUDWHGFDSDFLW\.
5DPPXVWEHRQDVWDEOHEDVHZKLFKLVDEOH
WRVXSSRUWWKHORDGZKLOHSXVKLQJRUOLIWLQJ
(QVXUH ram is IXOO\ HQJDJHG LQWRRQWR adapters,
H[WHQVLRQDFFHVVRULHV
TRKHOSSUHYHQWSHUVRQDOLQMXU\, use shims,
friction material or constraints to prevent
VOLSSDJHRIWKHEDVHRUORDG
Do not ofIFHQWHUORDGVRQDUDP
The load can tip or the ram can
³NLFNRXW´DQGFDXVHSHUVRQDO
LQMXU\.
Center loads on ram
As the load is lifted, use EORFNLQJ and FULEELQJ to
JXDUG DJDLQVW a IDOOLQJ load.
Never allow personnel to work on, under or
around a load EHIRUH it is SURSHUO\ supported E\
appropriate mechanical means. Never UHO\ on
K\GUDXOLFSUHVVXUHDORQHWRVXSSRUWORDG
$OOSHUVRQQHOPXVWEHFOHDUEHIRUHORZHULQJ
Never WU\ to GLVDVVHPEOH a K\GUDXOLF F\OLQGHr,
IMPORTANT
Keep ram clean at all times.
:KHQ the ram is not is use, keep the SLVWRQV
IXOO\UHWUDFWHG
Use an approved, KLJKJUDGH pipe thread sealant
to seal all K\GUDXOLF connections. T tape can
EH used if RQO\ one OD\HU of tape is used and it is
applied carefull\ two threads EDck to prevent the
tape from EHLQJ introduced into K\GUDXOLF V\VWHP
A piece of tape could travel WKURXJK the V\VWHP
and REVWUXFW the of and DGYHUVHO\ affect
function.
Never attach ANY
manufacturer.
1HYHUXVHRWKHUWKDQIDFWRU\SURYLGHGDQGRU
KNOW YOUR SYSTEM
Your ram, KRVHV FRXSOLQJV and pump all must EH
rated for the same PD[LPXP RSHUDWLQJ pressure,
FRUUHFWO\ connected and FRPSDWLEOH with the K\GUDXOLc
uid used. An LPSURSHUO\ matched V\VWHP can cause
the V\VWHP to fail and SRVVLEO\ cause serious LQMXU\.
!WARNING
Hydraulic Hoses and Fluid Transmission Lines
Avoid short runs of VWUDLJKW line WXELQJ 6WUDLJKW
line runs do not provide for H[SDQVLRQ and
contraction due to pressure DQGRU temperature
FKDQJHV
5HGXFH stress in WXEH lines. /RQJ WXELQJ runs
should EH supported E\ EUDFNHWV or clips. Before
RSHUDWLQJ the pump, all hose connections must
EH WLJKWHQHG with the proper tools. Do not
RYHUWLJKWHQ Connections should RQO\ EH WLJKWHQHG
VHFXUHO\ and OHDNIUHH 2YHUWLJKWHQLQJ can cause
premature thread failure or KLJK pressure
WREXUVW
Should a K\GUDXOLF hose ever rupture, EXUVW or
need to EH disconnected, LPPHGLDWHO\ shut off
the pump and release all pressure. Never attempt
to JUDVS a OHDNLQJ hose with \RXU
hands. The force of HVFDSLQJ K\GUDXOLF can
\.
Do not VXEMHFW the hose to potential such
as sharp REMHFWV H[WUHPH heat or cold, or
KHDY\LPSDFW
Do not allow the hose to kink, twist, curl, crush,
cut or EHQG so WLJKWO\ that the within
the hose is EORFNHG or reduced. 3HULRGLFDOO\
inspect the hose for wear, EHFDXVH DQ\ of these
conditions can GDPDJH the hose and SRVVLEO\
UHVXOWLQSHUVRQDOLQMXU\.
.esoheht\Eputesevomronoitisop,lluptonoD
'RLQJ so can GDPDJH the hose and SRVVLEO\
FDXVHSHUVRQDOLQMXU\.
+RVH material and coupler seals must EH
FRPSDWLEOH with K\GUDXOLF used. +RVHV also
must not come in contact with corrosive materials
such as EDWWHU\ acid, FUHRVRWHLPSUHJQDWHG
REMHFWV and wet paint. +RVH deterioration due to
corrosive material can result in personal LQMXU\.
Never paint a coupler or hose.
The user must EH a operator familiar
with the correct operation, maintenance, and use
of rams. Lack of NQRZOHGJH in DQ\ of these areas
can lead to personal LQMXU\.
Use RQO\ approved accessories and approved
'RQRWH[FHHGWKHUDWHGFDSDFLW\RIWKHUDP
Inspect each ram and coupler EHIRUH each use to
SUHYHQWXQVDIHFRQGLWLRQVIURPGHYHORSLQJ
Do not use rams if WKH\ are GDPDJHG altered or
in poor condition.
Do not use rams with EHQW or GDPDJHG coupler or
GDPDJHGWKUHDGV
Under certain conditions, the use of an H[WHQVLRQ
with a K\GUDXOLF ram PD\ not EH DGYLVDEOH and
could present a GDQJHURXV condition.