Atdec AF Series User manual

D
No portion of this document or any artwork contained herein should be reproduced in any way
without the express written consent of Atdec Pty Ltd. Due to continuing product development,
the manufacturer reserves the right to alter specifications without notice. ©20171013A
AC-GC Page 1 of 4AC-GC Page 4 of 4
Installation Guide
AC-GC
Grommet Clamp
Installed Position
A
A
Step 4.
Step 3.
ATDEC AWM-P
Go to Page 2
ATDEC AF-
Go to Page 4
ATDEC AWM-ADB
Go to Page 3
IMPORTANT INFORMATION
!IMPORTANT - Install Atdec Grommet Clamp as per Installation Instructions.
! The manufacturer accepts no responsibility for incorrect installation.
!This product is compatible with Atdec products AF-posts, AWM-P posts,
AWM-ADB, APM range, VFS range posts, SD-DP range posts.
! The product is compatible with grommet hole sizes from 60-80mm
! The product is compatible with desk thicknesses from 18-36mm
COMPONENT CHECKLIST
TOOL REQUIRED
Clamp Plate Clamp Bar
A
M8 Stud
B
M8x30mm
screw
C
M8x16mm
screw
D
M4x12mm
Screw (x2) 5mm Allen key M8 Nut 13mm Spanner
Phillips Head
Screwdriver
INSTALLATION WITH ATDEC AF- POST
Step 2.Step 1.
atdec.com | atdec.co.uk | atdec.com.au

AC-GC Page 3 of 4AC-GC Page 2 of 4
Step 2. Install Grommet Clamp on desk Step 2. Install Grommet Clamp on desk
A
B
BA
Installed Position Installed Position
A
C
CA
INSTALLATION WITH ATDEC AWM-P Posts
Step 1. Assemble Post to Grommet Clamp
INSTALLATION WITH ATDEC AWM-ADB
Step 1. Assemble Base to Grommet Clamp