Atdec TH-PFK User manual

To complete installation please jump to Step 5 of the TH-PF installation manual
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 21.03.13 ©
TH-PFK
Component Checklist
Pro AV Projector Ceiling Mount with 3” Pole
Coach Bolt (x4)
HARDWARE Tools Required:
• Power Drill
• 4.5mm(0.18”) Drill Bit
• 10mm (3/8”) Socket Wrench Shifter
• Phillips Head Screw Driver
! IMPORTANT - Install Telehook Ceiling Mount as per installation instruction.
! This product supports a maximum load of 25kg (55lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received all parts against the component checklist and hardware above.
M6 Washer (x4)
Security
Allen Key
Standard Set
Screw (x2)
Security Set
Screw (x2)
Mount
Step 2. Ceiling Mount
Step 3.
Cover
IMPORTANT! Any structural elements must be capable of
supporting the combined weight of all the equipment and devices
being mounted. If in doubt, consult a structural engineer.
Timber Stud Masonry
Coach Bolt
Screw in 3” Pole
M6 Washer
Mount
TIP: Use Mount as a drilling template.
Coach Bolt
M6 Washer
Mount
Clip on Cover
Holes to Suit Anchors
NYLON ANCHORS
NOT SUPPLIED
Ø4.5mm x 65mm
deep Drilled Hole
Secure pole by inserting
standard or security set
screws using supplied
Allen key
Side panels can be
snapped off to provide
cable route
Step 4. Step 5.
1
2
2
Installation Instructions
3” Pole TH-PF
Pro AV Projector Mount