Atdec Visidec Focus Articulated Arm Wall Operation instructions

USER
OPERATING CARD
Please do
not remove card from
the Visidec Focus
Articulated Arm Wall
For your comfort and safety please take a few
moments to adjust the position of your display
To adjust the Visidec Focus Articulated Arm
Wall, please refer to the instructions overleaf
Use the Ergonomic Guidelines on the back
page as a guide for correct positioning
Ergonomic Guidelines
Ergonomists recommend that the optimal position of your
screen should be slightly below eye level. When looking at the
screen’s centre the user should have a downward visual angle of
approximately 10°-20°. As a guide, the height (h) of your display
should be approximately as follows:
Tall Male (Max): 560mm (22”) Tall Female (Max): 520mm (201/2”)
Short Male (Min): 368mm (141/2”) Short Female (Min): 356mm (14”)
For visual comfort, a viewing distance (d) between 500mm (20”) to
750mm (291/2”) is recommended.
Angular adjustments to normalise or reduce reflection on your
display should range between 5° forward tilt to 15° backward tilt.
15°
5°
HORIZONTAL SIGHT LINE (d)
CENTRE OF SCREEN
10°-20°
(h)
Max.
454mm
(177/8”)
Many experts believe that the extended use of any
computer screen has the potential to cause serious injury
to your eyes, neck and back. This can be largely avoided
by correctly positioning your display.
Articu

Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice.
Adjusting Display Height
Adjust the height of your display as shown
A.1. Unlock
A.2. Adjust to
your preferred
height
A.3. Lock
A
Use the supplied 5mm Allen Key to adjust the tension of the Yoke.
Tighten
Loosen
Loosen
Tighten
5mm Allen Key
5mm
Allen
Key
Yoke
Published: 25.01.08©
atdec.com
Your Focus Articulated Arm Wall should already be preset to accommodate the
average size/weight of a display. To adjust the height of your display follow the
steps below, then simply hold both sides of the display and adjust to a comfortable
viewing position.
Mechanical Adjustment
B
If undesired tilt or pan occurs at any stage, this means the factory settings
on your Focus Articulated Arm Wall require adjustment. Please refer to
adjustment details below.
B.1. Yoke tension
B.1. Adjusting Yoke tension