Atdec Visidec Focus Micro Operation instructions

Many experts believe that the extended use of any computer
screen has the potential to cause serious injury to your eyes,
neck and back. This can be largely avoided by correctly
positioning your display.
Viewing Angle: Ergonomists recommend that the optimal position of your
display should be slightly below eye level. When looking at the display’s cen-
tre the user should have a downward visual angle of approximately 10°-20°.
Height: As a guide, the height (h) of your display should approximately
be as follows: - Tall Male (Max): 560mm (22”)
- Short Male (Min): 368mm (14½”)
- Tall Female (Max): 520mm (20½”)
- Short Female (Min): 356mm (14”)
Distance: For visual comfort, a viewing distance (d) between 500mm
(20”) to 750mm (29½”) is recommended.
Tilt Angle: Angular adjustments to reduce reflection on your display
should range between 5° forward tilt to 15° backward tilt.
USER
OPERATING CARD
For your comfort and safety please take
a few moments to adjust the position of
your display
Ergonomic Guidelines
To adjust the Visidec Focus Micro please
refer to the instructions overleaf.
Use the Ergonomic Guidelines on the
back page as a guide for correct
positioning.
Please do not
remove card from
the Visidec Focus
Micro

1 Adjusting Height
Step 3:
Lock
2 Adjusting the Display Bracket
Tighten
Loosen Tighten
Loosen
95º
Max.
Allen Key
Storage
USER OPERATING CARD
For your comfort and safety please take a few
moments to adjust the position of your display
TILT (screen angle up/down)
PORTRAIT/LANDSCAPE
PAN (screen angle left/right)
atdec.com Due to continuing product development, the manufacturer reserves
the right to alter specifications without notice.
Published
22.01.08 ©
Step 2:
Lift/Lower
Step 1:
Unlock