Atdec AWM-W35 User manual

AWM-W35 Page 1 of 2
Installation Guide
AWM-W35
Wall Channel
IMPORTANT INFORMATION
!Please ensure this product is installed as per these installation instructions.
! The manufacturer accepts no responsibility for incorrect installation.
!This product is not suitable for outdoor use.
!Do no use this product for mobile application.
!Wall Bracket only achieves maximum weight rating when appropriately fastened to a wall of adequate structural capacity.
!Professional installer to ensure adequate structural capacity of wall (including appropriate safety factor) to support total
weight of all equipment being mounted.
!Drilling into electrical wires can cause death - use appropriate equipment and caution when drilling holes in walls to avoid
electrical cables, water pipes and gas pipes. Do not drill into structures unless you have established it’s safe to do so.
!This product is only compatible with AWM Series products, including: AWM-A13, AWM-A46, AWM-A71 and AWM-ADC.
!This product is not compatible with the AWM Heavy Duty Heads, including: AWM-LTH and AWM-LR.
A
Wall channel
(x1)
E
Nylon
Anchor (x3)
C
Top Cap
Screws
(x2)
B
Top Cap
(x1)
D
M6 x 50mm
Countersunk
Screw (x3)
COMPONENT CHECKLIST
REQUIRED TOOLS
• Power drill
• Suitable drill bit
• Driver bit for
selected wall
fasteners
• Stud nder
• Spirit level
WEIGHT RANGE
0 - 12kg
(0 - 26.5lb)
Monitor weight should be within
the weight range of all modular
elements that make up the complete
monitor mounting solution.

AWM-W35 Page 2 of 2
3. Install top cap 4. Cable clips
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specications without notice. ©20221101
Phillips Head
Screwdriver
Top Cap
3.1 Attach Top Cap 4.1 Push the cable down into the Cable Clip.
4.2 Insert one side of the Cable Clip into
the Channel on the Post assembly or Wall
Channel, before pushing the other side in.
NOTE: Cable clips sold separately
in packs of four.
2. Fit channel clamp to wall channel
2.1 Ensure knob is undone. 2.2 Slide clamp into channel. 2.3 Hold clamp in desired position on
post and turn knob to lock in place.
1. Ensure Knob is undone
Push knob to
aid insertion
Tip: push knob
to aid insertion
2. Slide clamp into channel
3. Hold clamp in desired position on post and turn
knob to lock in place
1. Mount the Wall Bracket to the Wall
8mm (5/
16”) holes
Nylon anchors
M6 x 50mm
Screws
4mm (5/
32”)
holes
Stud
M6 x
50mm
Screws
OPTION 1: Masonry OPTION 2: Timber stud
Using the Wall
Channel as
a template,
mark the
three xing
hole positions
for drilling.
NOTE: On a Stud
Wall, use a good
quality Stud Finder
to position mounting
fasteners in the
centre of studs.
NOTE: Wall Channel
must be level. Verify
using a quality spirit
level tool positioned
along the side edge
of the wall channel.
OR
x3