Atlantic Furniture TWIN FULL User manual

ASSEMBLY INSTRUCTIONS
TWIN FULL > QUEEN KING
BED WITH BED DRAWER
FLAT PANEL BED DRAWER
Page 1 of 3
FLAT PANEL BED DRAWER
AJCB M6 X 1” ( 25mm ) - 16 pcs
Spare - 2 pcs BAllen Wrench - 1 pc
Spare - 1 pc
Adult Assembly
Allen Wrench
READY
Before assembling your Flat panel bed drawer, please read through these
Thank you for choosing our new Bed drawer.
This practical design offers the utmost in versatility.
instructions carefully. Familiarize yourself with the different parts.
NOTE: WE INCLUDE SPARE HARDWARE IN CASE THE ALLEN WRENCH OR JCB ARE DAMAGED DURING ASSEMBLY.
HARDWARE
ATTENTION! If you receive a damaged or defective item,
please contact Atlantic Furniture at [email protected] 1-800-955-3726 / M-F 9:00-5:00 EST

PARTS LIST
STEP 1 Lay the drawer face (02) on smoth, flat surface so the groove are facing upwards. Fit the drawer
side (03)(04) to drawer face (02), Use JCB M6 X 1” (A) to attach the drawer side in place, but
don't fully tighten these yet. Leave them a bit loose to make fitting the drawer back easier.
Page 2 of 3
FLAT PANEL BED DRAWER
ZOOM IN
01
02
03
HARDWARE 1 BOX
2 PCS
2 PCS
DRAWER FACE
LEFT DRAWER SIDE
04
05
06
2 PCS
2 PCS
2 PCS
RIGHT DRAWER SIDE
DRAWER BACK
DRAWER PANEL
01
05
03
03
04
04
06
02
02
A
A
A
Allen Wrench
Adult Assembly
A
B
JCB M6 X 1”

STEP 2
Guide the drawer panel (06) in carefully so that it won’t jump out of its grooves. Be sure it fits fully
into its groove at the bottom (in the drawer face) before fitting the drawer back.
STEP 3
Page 3 of 3
FLAT PANEL BED DRAWER
Adult Assembly
06
05
Allen Wrench
Adult Assembly
A
B
JCB M6 X 1”
Attach drawer back (05) to the bed drawer assemblies as shown bellow. Using JCB (A )
Tighten with allen wrench (B). After this tighten all JCB to the drawer face.
Repeat step 1 through 3 for second storage drawer.
A
A
A
A
Congratulations !
Your Flat panel bed drawer is now ready for use.