Atlantic Furniture NANTUCKET END TABLE CHARGING STATION User manual

Page 1 of 3
ASSEMBLY INSTRUCTIONS
Before assembling your end table, please read through these
instructions carefully and familiarize yourself with the different parts.
NANTUCKET END TABLE CHARGING STATION
A E
D
BF
C
Flat washer - 4 pcs Wooden dowel 3/8 X 1 1/4” - 4 pcs
Wooden dowel 1/4” X 1 1/4” - 4 pcs
Spare - 1 pc
Spare - 1 pc
JCB M8 - 4 pcs Wood screw - 8 pcs
Spare - 1 pc Spare - 2 pcs
Allen wrench - 1 pc
PARTS LIST
01
02
03
04
TOP PANEL 1 PC
4 PCS
2 PCS
1 PC
LEG
SIDE PANEL
LOWER SHELF
01
02
04
03
03
ATTENTION! If you receive a damaged or defective item,
please contact Atlantic Furniture at [email protected] or 1-800-955-3726
READY
ASSEMBLE
TO
Adult assemblyAdult assembly
NOTE: WE INCLUDE SPARE HARDWARE IN CASE DAMAGE OCCURS DURING ASSEMBLY.

Page 2 of 3
Install wooden dowels (D) and (E) into the
locator holes on (03) and (04) as shown below.
Attach first side panel (03) to end table
aligning the dowels with the holes in the
apron. Be sure the panel is centered before
tightening the wood screw (F).
F
F
D
D
D
D
EE
E
F
02
03
03
04 03
02
02
02
01
02
AA
BB
STEP 2 STEP 3
Attach the legs (02) to the top panel (01) using flat washers (A) and JCB (B), tighten
with Allen wrench (C), as shown below.
A
B
note: panel in center
Step 1
NANTUCKET END TABLE CHARGING STATION
Adult assemblyAdult assembly
Adult assemblyAdult assembly

Attach second side panel (03) the same as the first but place the lower shelf (04)
in position by aligning the wooden dowels with the holes in the side panel.
Apply presure to eliminate any gap between the lower shelf and the side panel
and fix in place using wood screw (F).
F
F
F
Page 3 of 3
04
03
Congratulations!
Your end table is now ready for use.
To ensure lasting safety, we recommend that you periodically check
that all screws are tight and all parts are secure.
Step 4
Step 5
Adult assemblyAdult assembly
Adult assemblyAdult assembly
NANTUCKET END TABLE CHARGING STATION