1
2. Thread the wire lace into the
in the order of hole 1→ hole 2→ hole 3
reel holes
1. Thread the wire lace into the
of the base
holes
Hole 3
Groove
Hole 2
Hole 1
Hole 3
Hole 2
Hole 1
3. Tighten the wire lace to be fixed it
~1.Press the end of lace and tighten the wire lace which between hole 3 and hole 2.
~2.Take the end of wire lace across the middle part of wire lace, then conceal from the first wire lace
(See figure B).Pull wire lace outward from hole 1, and keep1mm distance away from the hole 1,
and cut the rest of wire lace. (See figure C)
~3.Pull tightly outward from hole 1 and make sure the wire lace is out of the central of circle
(See figure D),please check it is in accurate location.(See figure E)
~4.Repeat the above steps to fasten the other side of wire lace.(See figure F)
(See figure A)
Make sure the wire lace is
out of the central of circle.
Press the wire lace at
this point by your finger.
The central of circle
groove
(figure A) (figure B) (figure C)
(figure E) (figure F)(figure D)
