Attainment Company Attainment Talker 24 User manual

Attainment Company’s
Attainment Talker 24
Instructions
On/O
button
Weight : 6.6 oz. — Recording time : 10 sec/message
Record
button
Record
LED
Microphone
Speaker
Reset
Message
buttons

Attainment’s AT24 records messages
and plays them back at the push of a
button. The ON/OFF button is on the
bottom. The available recording time is
10 seconds for each message.
Record a Message
• Turn on the AT24 .
• Press and hold a message button.
Continue to hold as you rmly press
and hold the Record button. (The red
Record LED turns on while recording).
• Speak into the microphone (Mic)
about 6 inches (15 cm) away.
• When you are nished recording,
release the Record button and then
release the message button.
Play Back a Message
Press and release the message button to
hear the recorded message.
Replace an Existing Message
Recording a new message will erase the

existing message on that button. Follow
the Record a Message procedure to
replace a message.
Batteries
This Attainment
Talker requires
two AAA batteries
(included). Turn
the device o
before changing
the batteries. The
battery door is on the end of the device.
Slide the door down, until it clicks, to
open the battery compartment. The
negative ends of the batteries go in the
compartment rst.
Trouble Shooting
• If recorded messages sound garbled or
unusual, insert new batteries.
• If recorded messages are not playing
back, use a pin to press and release the
Reset button. (Reset button does NOT
erase messages.)

AAttainment Company, Inc.
P.O. Box 930160 •Verona, WI 53593-0160 • USA
Phone [phone] • International 1-608-845-7880
www.AttainmentCompany.com
Add Visual Cues
The message buttons have a clear
plastic cover, which is sealed to the
device in the middle of the message
pad. The paper inserts, included with
the AT24, have twelve 3 /4” squares and
measure 13 /4” x 5” (4.4 cm x 12.7 cm).
Write cues, draw, or adhere images on
the squares over each button to indicate
the messages recorded.