Xiaomi PMA Graphene User manual

Happy using of the heating belt PMA Graphene Heating Belt!
Пожалуйста, подключите батарею к поясу, включите питание
для активации пояса.
1 - Switch;
2 - USB port;
3 - Battery pocket;
4 - Velcro;
5 - Grafen module emitting heat.

Heating belt PMA Graphene Heating Belt
Quick start guide
1 - Micro USB input connector;
2 - USB output connector.
Remove a mobile power source from the shipping box, connect
one end of the USB cable, that comes with the kit, to the output
connector of a mobile power source.
* PMA-A10 series products are NOT supplied with a battery, use
your own mobile power source or universal battery, use the
instructions in this manual.

1 - Switch;
2 - USB port;
3 - Pocket for the battery.
Place a mobile power supply in the pocket on your belt, connect
the other end of the USB cable to the USB port on your belt.
* The location of the batteries of different models in your pocket
may vary.

1 - Switch;
2 – Switch of thermostat (red, blue, green).
Press the switch on the mobile power source, turn on power on the
belt, the thermostatic indicator (under the PMA logo) will flash
alternately red, blue and green and go out: the belt power is turned
on.

Wear the belt part of the body that needs to be heated, and fasten
it with Velcro.

Press and hold the thermostat button for 3 seconds, the indicator
will turn red (high temperature mode), press the thermostat switch
again, the indicator will turn blue (middle temperature mode),
press the thermostat switch again, the indicator will turn green
(low temperature); select the desired temperature mode.

Press and hold the thermostat button for 3 seconds, the belt
power will turn off, then remove the belt.