AUDAC PX110 User manual

PROFESSIONAL AUDIO EQUIPMENT
Speaker Cabinet PX110
UserManual&InstallationGuide
Speaker Cabinet
PX110
AUDAC

1
A U D A C P R O F E S S I O N A L A U D I O E Q U I P M E N T
User Manual & Installation Guide
AUDAC
http://www.audac.be
[e-mail]
Before connecting or installing this product, first read these instructions carefully

2
Warning
Use only the correct amplifier output voltage and impedance, exceeding these limits could
cause fire or other failures.
Avoid explosions: do not use the speaker around gasoline, thinner or other combustibles.
Only install the speaker in locations that can structurally support the weight of the speaker and
the mounting bracket. Not doing this may result in the speaker falling down.
Do not use any other method than specified to mount the bracket (the mounting bracket that
is specified for this speaker is the MBK110). If extreme force is applied to the speaker, the
speaker could fall down.
Attach a safety wire to the speaker when it is mounted high above the ground. Failure in doing
so could cause the speaker to fall down for any reason.
Use fixing materials that are appropriate for the ceiling’s or wall’s structure and composition.
Failure to do so may cause the speaker to fall down.
Tighten each nut and bolt securely. Ensure that the bracket has no loose joints after
installation to prevent accidents.
Avoid mounting the speaker in locations exposed to constant vibrations. The mounting
bracket can be damaged by excessive vibrations, potentially causing the speaker to fall down.

3
Caution
Avoid electric shocks: switch off the amplifier power when connecting the speaker.
Avoid installing the speaker in locations exposed to solvents, acids, smoke and heaters, as
excessive exposure to these factors could result in speaker failure, fire or electric shock.
Do not operate the speaker for an extended period of time at distorted sound. This could
cause (irreparable) damage to the speaker.
Do not stand or sit on, nor hang down from the speaker as this may cause the speaker to fall
down or drop.
Appearance

4
Installation
Install the speaker with the mounting
bracket MBK110 in an appropriate
location. Tighten them with nuts and bolts.
To adjust the directivity of the speaker,
loosen the bolts at the top and bottom of
the mounting bracket. Then you can
position the speaker. Afterwards, tighten
the bolts firmly.
Connections
Plug the speaker cable into the socket at the
backside of the speaker.
Use speaker connections with the speaker
cable attached at +1,-1 of the connector.

5
Specifications
RMS Power 180 Watt
Max Power 350 Watt
SPL (1W/1M) 98 dB
SPL (Max/1m) 120 dB
Frequency Response -3 dB 80-18000 Hz
Frequency Response -10 dB 65-20000 Hz
Horizontal Coverage 90°
Vertical Coverage 60°
HF Driver 1 inch
LF Driver 10 inch
Crossover Frequency 2500 Hz
Impedance 8 Ohm
Dimensions (WxHxD) 315x545x325 mm
Weight 15.5 Kg
Mounting MBK110 (optional)
Color Black