Audio 2000 Plug-In-N-Recharge AWM6112 User manual

13 4 5 62
1. Microphone Windscreen
2. Microphone Housing
3. Low Battery LED Indicator
4. On/Off Switch
5. Battery Cover
6. Recharge Contacts

2.Connect the AWR6112 receiver AC cord to an AC power source. Make sure that
the 120V/240V voltage selection switch under the AC input is set to the proper
voltage. It should be set to 120V in North America.
4.Place two rechargeable AA batteries into the battery housing of each
of the AWX6112 microphones with the battery polarity orientations as
indicated. The rechargeable batteries need to be recharged immediately
if the red low-battery LED indicator on the AWX6112 is on. If the batteries
need to be recharged, insert the AWX6112 microphones (with the recharge
contacts facing downwards) onto the recharge sockets on the AWR6112
receiver. (Note: Never recharge any battery that is not made to be
rechargeable.) The rechargeLED indicators on the AWR6112 receiver
will turn red when the batteries in the AWX6112 are being recharged.
After the batteries are fully recharged, the recharge LED indicators will
turn green.
NOTE: Before recharging the batteries in the AWX6112 microphones,
the power of the AWR6112 receiver needs to be TURNED OFF.
If the power of the AWR6112 receiver is on, only one AWX6112
microphone is allowed to be in the recharge socket for the
rechargeable batteries to be recharged. When the power of the
AWR6112 receiver is ON and both AWX6112 microphones are
in the recharge sockets, the batteries in both AWX6112 microphones
will NOT be recharged.

65