Audio ACCESSIBILITE DCTSG1 User manual

Test Signal Generator
DCTSG1
User Guide
February 2017

Contents
Product Overview
Set-Up
Handy Tips
Troubleshooting
3
4
5
5
Contacta has a policy of continuous product development, therefore small specication changes
may not be reected in this manual. Images, labels, packaging, accessories and product colours
are subject to change without notice.

3
Product Overview
Our Test Signal Generator (TSG1) is a compact, handheld engineer’s
tool for large area hearing loop installations. When combined with our
Field Strength Meter (IL-CONTACTA-FSM), it veries whether a hearing
loop is working to the BS EN 60118-4 standard.
It provides continuous sine wave frequencies, allowing measurement
of hearing loop systems.
The generator has the following signal settings:
• 100Hz
• 500Hz
• 1KHz
• 1.6KHz
• 4KHz
• 5KHz
• White noise
• Pink noise

4
Set-Up
1. Open the rear of your Test Signal Generator (see
diagram on the right) and insert two alkaline AA
batteries.
2. Plug the XLR connection lead into the line input
of the hearing loop driver being tested.
3. Press the power/pause button to turn on the
Test Signal Generator (see diagram below).
4. Press the power/pause button to switch
between frequencies.
Frequency
Indicator
Power/Pause Button
& Frequency Change
XLR
Connection Lead
5. To turn o the device, hold the power/pause button down for three
seconds.

5
Handy Tips
The device will automatically power o if not used for one hour.
The following procedures should be carried out on a regular basis to
keep the product at its optimal performance:
• Do not stretch or wrap the cable
• Clean with a dry soft cloth
• Do not use solvent based cleaners
Troubleshooting
Symptom Possible Fault Action
There is no
response when
the Power Button
is pressed.
1) The battery is low/at.
2) Faulty button or
internal failure.
1) Replace with new
alkaline AA batteries.
2) Seek assistance.
If no action is successful please seek assistance from
your distributor or a Contacta installer.

6

7

Local dealer
Audio Accessibilité By ARCHEAN Technologies
1899 Avenue d’Italie, ZI Alba sud II, 82000 Montauban, France
[phone]
[email protected]
www.audioaccessibilite.tech