AUTOTECH 10.411.01.219K User manual

Installation Instructions
Procedure:
When installing Autotech Sport Springs on 1994 and 1995 Golf or Jetta VR6 models, it is recommended to
shorten the length of the original urethane foam bump stop on the front shock to allow greater suspension
travel.
Using a sharp hobby knife or small saw (a coping saw works well), cut the stop at the line as indicated in
the illustration below.
Retain the upper portion of the stop and re-install on the piston rod.
Make sure to put the dust cover back on the shock as well
Notes: The rear shock bump stop should be used in its original length.
Part Number: 10.411.01.219K
Description: Autotech Sport Spring Set for Mk3 VR6