Avue AV665SCW28 User manual

AV665SCW28
Thank you for purchasing our product. Before attempting to connect or
operate this product, please read the instructions carefully before use.
DESCRIPTION
AV665SCW28 has advanced imaging technology with
resolution as high as 700 TVL, true color, IR SMART control,
waterproof housing, etc… to provide 24-hour continuous
monitoring.
PRECAUTIONS
1. Use appropriate power supply.
The power input for AV665SCW28 is DC12V. Using wrong power
source will damage the camera permanently.
2. Do not attempt to disassemble the camera.
There is not serviceable parts.
3. Handle the camera with care.
Avoid abusing the camera by striking, shaking, or other improper
handling.
4. Do not place the camera in the following locations:
a. Where temperature is lower than -4 ℉ or higher than 131 ℉;
b. Where humidity is higher than 90%.
5. Clean the CCD faceplate with care.
Do not use strong detergents. Use a piece of lens tissue or cotton
tipped applicator and ethanol.
6. Do not attempt to aim the camera at the sun.
Aiming at the sun or other extremely bright objects causes smear to
appear irrespectively of whether the camera is operating or not. This
can damage the CCD.
7. Do not put the camera in places with interference.
When this camera is installed near the equipment like wireless
communication device that emits strong electromagnetic field, some
irregularities such as noise on the monitor screen may happen.
FEATURES
● ⅓” PixelPLus 1099K CMOS Sensor
●High Resolution 700 TVL, true color
●IR SMART control
●Low power consumption (360mW), low heat dissipation
●Ingress Protection Rated IP66: Dust & Weather Proof
●Simple to operate
PARTS INSTRUCTIONS
1. Ring Enclosure
2. Camera Holder
3. Base
4. Camera Lens
5. Wire Out Hole
6. Four install screws holes (on base)
www.avueinc.com

DIMENSION
CONNECTIONS
SETUP
Camera Installation:
1. Unscrew the ring enclosure,
take it out.
2. Using the foam pat to locate
the holes in the wall.
3. Drill 4 holes in the position
needed in accordance with the
holes on the base. Push the
expansion bolt inside, then
screws the base to the
expansion bolt holes loosely.
4. Get the wire out from the wire
out hole through the base.
5. Screw tightly the base to the
wall.
6. Screw the enclosure to the
base with the ring enclosure.
SPECIFICATIONS
Sensor
⅓” PixelPlus 1099K CMOS
Effective Pixels
976H * 496V
Scanning System
2:1 Interlaced
Sync. System
Internal
Resolution
700+TVL
Lens
2.8mm
Mini Focal Distance
7.87in / 20cm
Day & Night
Ext
S/N Ratio
47 dB (AGC Off)
White Balance
AUTO
Video Output
1.0V p-p Composite Video Output, 75Ω
Power Source
DC 12V ± 10%
Power Consumption
200mA, 2.4W
IR LED
24 Units IR LED
IR Distance
75 Feet
Min. Illumination
3 Lux
Operating Temp.
-4 ~ 131 ℉ / -20 ~ 55 ℃
Dimension (⌀ x H)
⌀93 x 75.5 mm
Weight
0.88 lb / 400g
www.avueinc.com