Axema C18 Instruction manual

Axema Access Control AB | Box 90215 | 120 23 Stockholm, Sweden | [phone] | i[email protected] | www.axema.se
Radio module C18, 2-3180
C18 is used for remote opening of e.g. gates or doors.
Connection instructions
Updated11/26/2020

Introduction
C18 Radio Module is an add-on module with integrated radio receiver for VAKA systems. The com-
munication between transmitter and receiver is encrypted with, "jumping keys", to prevent eaves-
dropping.
VAKA's radio system communicates at a frequency of 868 MHz and Axema's radio keys have
unique IDs that enable tracking in the system's event log. The RN18-4 radio key has four different
buttons, all of which can have different functions, such as remote door opening or remote control of
relays in the C17 module. The radio key RN18-1 has one button that corresponds to the A button
on RN18-4. It is possible to mount several C18 modules in the same system, but, then it is recom-
mended that different buttons on the radio key are programmed for each C18 module.
C18 is delivered with a small quartz wave antenna that must be positioned vertically for best cov-
erage. Optimal mounting of the antenna requires an intervention in the door controller enclosure. If
longer reading distances are required, for example for gate and gate control, there is an external
antenna (MMCX connector) with 3 m of cast cable (Article number, 2-5010). If only very short read-
ing distances are required, no antenna needs to be used.
Mounting
lWhen broadcasting through exterior wall or concrete wall, for example for garage ports
control, an external antenna is recommended.
lWhen broadcasting through inner walls, for example a plaster wall between front door and
office, the quartz antenna is recommended.
lWhen broadcasting in an office environment the quartz antenna is recommended.
Depending on the desired range, the C18's integrated antenna may be sufficient.
lMetal cabinets and the like, shield radio waves and can completely eliminate reception.
Place the antenna as far away from metal objects as possible.
2(4) Connection instructionsC18

Quartz antenna in an indoor environment
lCut off a small part of the right corner in the cover of the door controller, see picture.
lWhen the module is mounted, it must be mounted in the right module slot and the antenna
drawn through the cut hole and positioned vertically.
External antenna
The C18 is equipped with an MMCX connector for connecting an external antenna. The cable for
Axema's antenna for extra range (2-5010) can be routed as shown.
1. Power off the controller.
2. Connect any antenna to the module.
3. Mount the module in a suitable slot in the door controller.
4. Power up the controller.
3(4) Connection instructionsC18

Installation and configuration
This manual only covers the installation and connection of the unit.
For information of how to configure the unit, see the manual for VAKA commissioning
(https://info.axema.se?commissioning).
For configuration of motor lock settings, see section Access control -> Motor lock in the com-
missioning manual. (https://info.axema.se?commissioning)
For configuration of the C12, see section Volume settings in the commissioning manual.
(https://info.axema.se?commissioning)
4(4) Connection instructionsC18