Axema C30 User manual

Axema Access Control AB | Box 90215 | 120 23 Stockholm, Sweden | 08-722 34 40 | [e-mail] | www.axema.se
C30 Memory Expansion Module
C30 allows VAKAto support up to 4000 users.
Manual
Updated 2018-11-17

C30 Memory Expansion Module
Introduction 3
Mounting and Installation 3
Before you call technical support 3
2 (3) Manual C30

Introduction
C30 Memory Expansion Module is developed to increase the maximum amount of
people in a VAKA 10 system from 1024 to 4000. Only one C30 is required per sys-
tem.
Mounting and Installation
1. Remove power from the door controller
2. Connect the module to one of the two connectors in the controller and apply
power to the controller.
3. Log in as installer in the VAKA software
4. VAKA will automaticaly detect the new hardware and a dialog ( New
hardware detected ) will appear.
5. Click on the dialog and follow the instructions to install the module.
6. New hardware can also be installed under Settings - Installation - Installation
of Reader / Module .
7. Log out and back into VAKA again.
Before you call technical support
The module can be removed and exchanged without loosing any settings.
However, the personal data cannot be administrated while the C30 is unmounted.
3 (3) Manual C30