Axema RD-200 User manual

Axema Access Control AB | Box 90215 | 120 23 Stockholm, Sweden | 08-722 34 40 | [e-mail] | www.axema.se
USB reader RD-200/300
Manual
Updated 2018-11-17

USB reader RD-200/300
Introduction 3
Installing the software 3
Configuration 3
RD200 - EM 3
RD200 & RD300 - Mifare 4
2 (4) Manual RD200 and RD300

Introduction
The reader is configured to work with VAKA. This manual is only required if the
reader should be reset or used with Axbase3000.
EM: PCPR 1-9028-3
Mifare: PCMIF 1-9028-4
Installing the software
1. Put the supplied disc into a computer.
2. Open the folder RD200 or RD300 .
3. Start the program RD200_RD300_Tools_VXXXX.exe .
Configuration
RD200 - EM
1. Set the USB reader to PCPR 1-9028-3.
2. Open the USB reader software.
3. Click on Get Current Setting .
4. Select USB Keyboard Emulation under USB Mode: .
5. Select 10H->13D under ID Format for VAKA, 6H->8D for Axbase.
6. Select Add Enter (CR) .
7. End by pressing Set to the left of Get Current Setting .
8. Select the tab Command test and select the field (Ascii) .
9. Read a tag and make sure the numbers are correct.
3 (4) Manual RD200 and RD300

RD200 & RD300 - Mifare
1. Set the USB reader to PDMIF 1-9028-4.
2. Open the USB reader software.
3. Click on Get Current Setting .
4. Select USB Keyboard Emulation under USB Mode: .
5. Select 8H->10D under ID Format for Axema Mifare Classic (AM12345678),
14H->17D for Mifare DESFire or 8H for Axbase with Mifare Classic or
DESFire.
When using Axbase, Axema Classic tag has to be read directly to Axbase.
6. Select Add Enter (CR) .
7. End by pressing Set to the left of Get Current Setting .
4 (4) Manual RD200 and RD300